- ページ 2

エアーコンプレッサー Draper VSC/UNIのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Draper VSC/UNI 4 ページ。 Universal valve spring compressor

Universal Valve Spring Compressor

This tool has been designed specially for removing and installing valve springs and seals

without the need to remove the cylinder head from the engine block. However it can also be

used on a cylinder head which has been removed from the block.

WARNING: Always wear safety goggles when using this tool.

1. Secure the two upright supports to the head

using the bolts supplied or Cam cover

fixings. (Do not fully tighten the bolts at this

time). See FIG 1.

2. Locate the compression handle (A) into the slot

in the valve adaptor (B) and secure using

one of the securing pins (C), see FIG 2.

NOTE: There are several holes located in both

the compression handle and valve adaptor,

these are for the proper location of the adaptor

on the valve.

3. Locate the support bar through the upright

supports as shown in FIG 3.

NOTE: There are seven holes in each upright for

correct positioning of the valve adaptor.

4. Remove the spark plugs or diesel injectors from

the engine.

5. Screw the required adaptor into the plug or

injector of the valve spring or valve guide to

be replaced and tighten (finger tight), see FIG 4.

6. Connect the adaptor to an air supply at 90PSI.

7. Place the compression handle under the support

bar noting that there are two locating

slots on the handle. See FIG 5.

INTRODUCTION

ASSEMBLY

Fig.1.

Fig.2.

✫✌

- 1-

✪✌

✬✌

Fig.3.