- ページ 7

グラインダー Draper Storm Force 56457のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Draper Storm Force 56457 20 ページ。 230v 650w

HEALTH AND SAFETY INFORMATION

Remove and check setting tools. Some machinery requires the use of additional tools or keys to set,

load or adjust the power tool. Before starting the power tool always check to make certain they have

been removed and are safely away from the machine.

Prevent unintentional starting. Before plugging any machine in to the power supply, make sure the

switch is in the OFF position. If the machine is portable, do not hold the machine near the switch and

take care when putting the machine down, that nothing can operate the switch.

Carefully select an extension lead. Some machines are not suitable for use with extension leads. If

the tool is designed for use outdoors, use an extension lead also suitable for that environment. When

using an extended lead, select one capable of handling the current (amps) drawn by the machine in

use. Fully extend the lead regardless of the distance between the power supply and the tool. Excess

current (amps) and a coiled extension lead will both cause the cable to heat up and can result in fire.

Concentrate and stay alert. Distractions are likely to cause an accident. Never operate a power tool if

you are under the influence of drugs (prescription or otherwise), including alcohol or if you are feeling

tired. Being disorientated will result in an accident.

Have this tool repaired by a qualified person. This tool is designed to conform to the relevant

international and local standards and as such should be maintained and repaired by someone

qualified, using only original parts supplied by the manufacturer. This will ensure the tool remains safe

to use.

5.2 SPECIFIC SAFETY INSTRUCTIONS FOR GRINDER USE

Have this tool repaired by a qualified person. This tool is designed to conform to the relevant

international and local standards. As such, it should be maintained and repaired by someone qualified,

using only original parts supplied by the manufacturer – This will ensure the tool remains safe to use.

– Check that speed marked on the wheel is equal to or greater than the rated speed of the grinder.

– Ensure that the wheel dimensions are compatible with the grinder.

– Abrasive wheels must be stored and handled with care in accordance with manufacturer's

instructions.

– Inspect the grinding wheel before use. Do not use chipped, cracked or otherwise defective

products.

– Ensure that mounted wheels and points are fitted in accordance with the manufacturer's

instructions.

– Ensure that the abrasive product is correctly mounted and tightened before use.

● Run the tool at no-load for 30 seconds in a safe position.

● Stop immediately if there is considerable vibration or if other defects are detected. If this

condition occurs, check the machine to determine the cause.

– Never use the angle grinder without the safety guard.

– Do not use separate reducing bushings or adapters to adapt large hole abrasive wheels.

– Check that the work piece is properly supported.

– Do not use cutting wheel for side grinding.

– Ensure that sparks resulting from use do not create a hazard e.g. do not hit persons, to ignite

flammable substances.

– Always use eye and ear protection.

– Personal protective equipment such as dust mask, gloves, helmet and apron should be worn.

– The wheel continues to rotate after the tool is switched off.

- 7 -