- ページ 6
室内装飾品 Draper Exterior FlexShade ClutchのPDF 取付・取扱説明書をオンラインで閲覧またはダウンロードできます。Draper Exterior FlexShade Clutch 8 ページ。
ページを印刷する
Exterior FlexShade
Exterior window shade with smooth, quiet operation, and independent control
Section 5 - Wall Mounted Brackets with Side Cables
Figure 10
OR
- Clutch
®
1. Mark wall for placement of mounting brackets.
Caution: Before mounting shades, verify measurements on card provided with shade, and
ensure brackets are installed at correct width.
2. Drill small starter holes
(if necessary)
3. Attach cable deck or wall mount to mounting surface.
4. Check cable length required, cut cable and strip approximately ½" of protective jacket.
5. Loosen screw in
3
/
" wire clamp, place clamp into middle hole of shade bracket
32
bracket), then thread cable through holes in wire clamp as far as stripped jacket will allow
6. Secure cable to bracket by re-tightening screw in wire clamp
from outside of bracket.
7. Allow cable to hang down to verify that cable has been cut
to proper length. Make adjustments to cable length
(Fig.
11).
as required
8. Mount brackets using appropriate fasteners for surface.
in mounting surface.
Figure 11
page 6 of 8
(from outside of
(Fig.
10).
OR