- ページ 2

室内装飾品 Draper FlexShadeのPDF 説明書インストールと操作をオンラインで閲覧またはダウンロードできます。Draper FlexShade 12 ページ。 Exterior clutch-operated shade
Draper FlexShade にも：インストレーション＆オペレーションマニュアル (8 ページ), インストレーション・インストラクション (2 ページ), 取扱説明書 (12 ページ), 取付・取扱説明書 (11 ページ), 説明書インストールと操作 (12 ページ), 説明書インストールと操作 (16 ページ), 説明書インストールと操作 (4 ページ), 取扱説明書 (7 ページ), 説明書インストールと操作 (16 ページ)

ページを印刷する

Exterior Clutch-Operated FlexShade

PLEASE READ - Important Safety Information

Important Safety Information

Improper installation and use of the Exterior Clutch-Operated FlexShade

to imprecise installation, mishandling of the shade during installation, or installation on an insufficient wall or ceiling structure. Please use extreme care.

1. Please read the following installation guidelines thoroughly and follow them

carefully. Failure to do so may cause product to fall or otherwise fail, and could

result in serious injury.

2. Installation and calibration of the shade should only be performed by an

authorized, qualified, and experienced professional.

3. Do not affix the unit to wall or ceilings that have inadequate strength to

permanently hold the unit during use. It is the owner's and installer's

responsibility to confirm the wall or ceiling to which the unit attaches is

sufficient to permanently hold the weight and stress loads of the unit at all

times. Draper

, Inc., is not responsible for improper installation, application,

testing, or workmanship related to the product at place of installation.

4. It is the installer's responsibility to make sure appropriate fasteners are

used for mounting.

5. All brackets, fascia, headboxes, pockets, wall clips, and other hardware

must be installed level. Shade unit must be level and square.

6. Before testing or operation, carefully inspect the entire area and path

of the shade and areas underneath the shade to be sure no persons

or objects are in the area.

1. Look for any job site conditions that could interfere with installation or

operation of the system.

2. Read carefully and be sure to understand all installation instructions and all

related operations manuals. These instructions are intended to serve as a guide

for the installer and owner. They should be followed closely and combined with

the expertise of experienced qualified installers. Draper, Inc., is not responsible

for improper installation, application, testing, or workmanship related to the

product at place of installation. Please retain all instructions for future use.

ANSI/WCMA A100.1-2018 standard

was established on December 15, 2018, to eliminate strangulation hazards for small children from hanging cords and chain loops.

When Draper

dealers specify that custom shades comply with ANSI/WCMA A100.1-2018, Draper provides a pre-installed Spring-Loaded

Chain Tension Device

(shown at right)

included. When properly installed, the tension device prevents the creation of a hazardous loop by maintaining tension on the bead chain.

If not installed properly, the shade is partially inoperable. A warning label

For more information, please see the Draper ANSI/WCMA A100.1-2018 compliance page:

PLEASE READ - Field Adjustments

Each Draper Solar Control Shade is tested to

ensure proper operation. Even with this testing,

some field adjustments may be needed for

telescoping.

If the shade is telescoping, place a piece of

shimming fabric into the fabric roll when the shade

is deployed on the side that the fabric will be drawn

toward. For example: if the fabric is tracking to the

left, place the shimming fabric on the right side.

WARNING

Before Beginning Installation

Child Safety Information

(developed by the Window Coverings Manufacturer's Association and the Consumer Product Safety Commission)

for clutch-operated units. A warning label is attached to the kit and approved mechanical fasteners are

PLEASE READ - Cleaning and Maintenance

Window covering products manufactured by Draper, when properly installed, should require no operational

maintenance or lubrication.

Most standard Draper fabrics may be cleaned at the window by vacuuming with a soft brush attachment.

They also may be cleaned by using a sponge or soft cloth and mild solution of warm soapy water. A mild

dishwashing liquid is recommended. A clean dry cloth is recommended for the metal finish.

Please Note: Exceptions are GreenScreen Evolve

SW7000 fabrics, which must be cleaned with a dry art sponge.

(GreenScreen Revive

registered trademark of Phifer

can result in serious injury or death. Primarily, injuries can occur if the unit falls due

7. During testing or operation, carefully watch the surrounding area for any

potential safety concerns including nearby persons or objects.

8. After installation, the entire system should be carefully tested to ensure safe

and normal operation. Extreme care should be taken during testing to remain

clear of moving parts to avoid possible injury.

9. Operation of shade should be performed only by authorized and qualified

personnel, who have been trained in the safe and effective operation of the

shade and understand its safety features.

10. The safety features of the shade should never be disabled, bypassed, or

overridden. The system should not be operated until all safety features are

properly and completely installed, calibrated, and tested.

11. Shade may need to comply with local, state, or district rules and regulations, in

particular when installed in schools. All applicable rules and regulations should

be reviewed before installation and use.

12. Failure to precisely follow installation guidelines invalidates all warranties.

13. Custom products/installations may not be reflected in this manual.

Call Draper, Inc., if you have questions regarding your installation.

3. Open cartons lengthwise, taking care not to cut into cardboard shipping

container.

4. Locate and lay out all pieces.

5. Inspect all boxes to make sure you have received the proper shade and parts.

6. If you have any difficulties with installing, servicing, or operating your shade,

call your dealer or Draper, Inc., 765-987-7999.

is also added to the shade roller.

(shown below)

www.draperinc.com/windowshades/wcmacompliance.aspx

and GreenScreen Evolve

are registered trademarks of Mermet

Incorporated.)

page 2 of 12

Important Safety Information

, GreenScreen Revive

, Flocké

, and Phifer

USA. SheerWeave

is a