- ページ 5

サンダー Draper 65084のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Draper 65084 20 ページ。 Dual action air composite sander
Draper 65084 にも：ユーザーマニュアル (16 ページ)

ページを印刷する

4. Health and Safety Information

Important: These instructions are intended as a guide to

the safe use of this product. Additional or specific risks

associated with each operation and workpiece material

must be undertaken before each operation. DO NOT

operate this tool if you are unfamiliar with the risks

associated with its use.

4.1 Health and Safety Instructions for this

Air Sander

WARNING! Read and understand the safety

instructions before installing, operating,

repairing, maintaining, replacing accessories,

or working near the sander. Failure to do so can

result in serious bodily injury.

General Safety Instructions

• Only trained and authorised personnel may install,

adjust or operate the sander.

• DO NOT modify this sander.

− Modifications can reduce the effectiveness of

safety measures and increase the risk of injury.

• Retain these instructions for the life of the

product and pass them on with the tool to any

future operators.

• DO NOT use this sander if it shows any evidence of

damage or disrepair.

• Regularly inspect the sander to ensure that all safety

markings remain legible.

− Contact Draper Tools if the safety markings need

to be replaced and DO NOT use the tool.

Projectile Hazards

• Be aware that failure of the workpiece, accessories or

tool itself may generate high-velocity projectiles.

• ALWAYS wear impact-resistant eye protection during

operation of the sander and assess the grade of

protection required with each use.

• When working overhead, ALWAYS wear a

safety helmet.

• Carefully assess the risk to others before every

operation and ensure that all bystanders are clear

of the work area or equipped with suitable

protective equipment.

− Keep this product out of reach of children at

all times.

• ALWAYS ensure that the workpiece is firmly

gripped by a clamp or vice; NEVER hold the

workpiece by hand.

Entanglement Hazards

• Keep loose clothing, gloves, hair and jewellery well

away from the sander at all times.

− Entanglement in the spinning pad can cause

significant injury.

Operating Hazards

• Wear suitable protective gloves to guard against

injury from cuts, abrasion and heat.

• If the workpiece becomes hot during operation,

stop the tool and allow the material to cool

before continuing.

• Hold the tool correctly and firmly and brace

yourself against sudden movements, keeping both

hands available.

• Maintain good balance and secure footing at all times

while operating the tool.

• Release the trigger lever immediately if the air supply

is interrupted.

• ONLY use lubricants recommended by Draper Tools.

• ALWAYS wear protective safety glasses while using

this tool.

− Draper Tools also recommends wearing protective

gloves and other protective clothing appropriate

to the specific conditions of the operation.

• Inspect the backing plate for signs of damage before

EVERY use.

− DO NOT use the sander if the backing pad is

broken or cracked or the tool has been dropped.

• NEVER touch the backing plate or sanding sheet

while the tool is in operation.

− ALWAYS allow the tool to come to a complete stop

and disconnect the air supply before handling or

adjusting the sanding pad or backing plate.

• NEVER use the tool without a suitable sanding

pad attached.

• Use on plastic or other non-conductive materials

increases the risk of electrostatic discharge.

• Dust and fumes caused by sanding operations may

create potentially explosive environments.

− ALWAYS ensure that dust extraction or

suppression systems are used with this tool and

are suitable for use with the workpiece materials.

– 5 –