- ページ 11

サンダー Draper 98427のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Draper 98427 20 ページ。 230v oscillating spindle sander

ページを印刷する

PREPARING THE SANDER

Note: Remove the plug from the socket before

carrying out adjustment, servicing or maintenance.

WARNING: When lifting this machine, please

ensure that there are two people lifting as it is

heavy item.

8.1

ATTACHING THE RUBBER FEET

- FIG.1

Lower the Sander onto its side and remove the

feet

from their protective wrappings.

Remove the nut and washer from the thread.

Locate the four mounting points underneath the

sander on each corner and insert the thread of the

rubber foot into the mounting hole so that the foot

points downward.

Place the washer onto the foot then followed by the

nut and tighten with a spanner (not supplied).

Repeat this procedure for the other 3 x feet.

Place and site the sander at a suitable height

allowing sanding operation to be carried out

comfortably and in a safe manner.

8.2

INSTALLING THE SANDING

SLEEVES ONTO THE RUBBER

DRUMS/BOBBIN - FIG. 2

This sander has been supplied with 3 x sanding

sleeves and 3 x rubber drums, sizes; 50mm, 38mm

and 19mm. Thee sleeves are already installed onto

each drum.

To change the sleeve on the drum once its become

worn, see Fig.2 for a detail breakdown of the sheet

and drum.

The bobbin consists of a rubber drum body with a

central metal axle passing through it. The axle has

a key which locates into a keyway in the rubber

body. This should not be altered unless the rubber

body has become damaged. At either end of the

rubber body are two large compression washers.

At the top is a washer and nute which allows you to

secure the sanding sleeve to the drum. The lower

part of the axle is threaded which will in turn, locate

into the main motor

FIG.

FIG.2

– 11 –