ページを印刷する
What to do if ...
Water is running out.
Water not flowing in.
Detergent not washed in.
The
(Ready) and
(End)
indicator lights flash.
Washing machine door cannot be
opened.
Programme does not start.
The
(Ready) and
(Rinse)
indicator lights flash.
Detergent solution is not drained.
The
(Rinse) and
(End)
indicator lights flash.
Additional function could not
activate for selected programme.
Water not visible in the drum.
Spin cycle actuated several times. – Not a fault - unbalanced load detection system adjusts
Detergent in chamber I is not
washed away.
Detergent residue in the detergent
dispenser
Foam is coming out of the
detergent drawer.
Excessive noise, vibrations and
"wandering" during spin cycle.
Indicator lights do not function
while the appliance is running.
Programme sequence longer than
usual
Detergent residues on the laundry – Occasionally, phosphate-free detergents contain water-
Washing result not satisfactory
If you cannot correct a fault yourself or a repair is required:
– Set the programme selector to Off and pull the mains plug out of the socket.
– Turn off the tap and call the customer services.
– Fit/refit drainage hose.
– Tighten screw–fitting on the supply hose.
– Tap not open?
– Filter blocked? Clean filter
Page 9.
– Water inlet hose kinked or jammed?
– Safety function active. Programme stopped?
– Water in drum? Select Spin
or Empty
– Start/Pause
not selected.
– Washing machine door not closed properly.
– Clean detergent solution pump
Page 9.
– Clean outlet pipe and/or drainage hose.
– Can the additional function be selected?
programme overview.
– Not a fault - water below the visible area.
imbalance.
–
+ Prewash
60
programme not selected ?
– Detergent is damp or lumpy, clean the detergent
dispenser
Page 8.
– Use the dosing aid for liquid detergent.
– Too much detergent used?
Mix 1 tablespoon of fabric conditioner with ½ a litre of
water and pour into dispenser II in the detergent drawer.
– Reduce detergent dosage for the next wash cycle.
– Appliance feet fixed?
Secure appliance feet
Installation instructions.
– Transportation bolt removed?
Remove transportation bolt
Installation instructions.
– Power failure?
– Circuit breaker tripped? Reset the circuit breaker/
change the fuse.
– If the fault occurs repeatedly, contact customer service.
– Not a fault-unbalanced load detection system is
adjusting the imbalance by repeatedly distributing the
laundry .
– Not a fault - foam detection sysytem active.
insoluble residues.
– Select Rinse
or blush the laundry after washing.
– Soiling is greater than expected? Select a suitable
programme or reduce load.
– Detergent is underdosed?
.
Page 7,
Washing machine
en Instruction manual
11
WLX20061BY