- ページ 4

録音機器 Drawmer 1977のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Drawmer 1977 12 ページ。 Channel strip
Drawmer 1977 にも：クイック・スタート・マニュアル (2 ページ)

The 1977 is designed for standard 19" rack mounting and occupies 2U of rack space. Fibre or plastic

washers may be used to prevent the front panel becoming marked by the mounting bolts.

- Care should be taken in the choice of positioning. The unit should not be mounted where

other equipment obstructs the normal air flow. The unit should not be situated near any heat source,

such as a radiator, stove or a high power amplifier that would generate heat.

- The appliance should not be operated near any water or in a location where moisture might be present.

- Always connect the mains earth to the unit.

If the 1977 is to be continuously moved from one location to another, we suggest using additional support

in the rack at the rear of the unit.

The unit will have been supplied with a power cable suitable

for domestic power outlets in your country. For your own safety

it is important that you use this cable. The unit should always

be connected to the mains supply earth using this cable, and

no other.

If for some reason the unit is to be used at a

mains input operating voltage which is different

to that as supplied, the following procedure must

be carried out.

1: Disconnect the unit from the mains.

2: Remove the two screws holding the voltage

selection cover-plate.

3: Remove the cover plate and slide the switch

fully to its opposite end.

4: Rotate the cover plate one half turn (180

degrees) and refit the two screws.

5: Replace with a correctly rated fuse for the

selected

operation voltage in the IEC

socket:

230V-T250mA and 115V-T500mA

6: Re-connect to mains power source.

Never disconnect the earth

from the mains supply

INSTALLATION

DRAWMER 1977 O

PERATOR'S

IEC SOCKET FUSE DRAWER

ANUAL