- ページ 7

プロセッサー Drawmer DL231のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Drawmer DL231 10 ページ。 Dual expander compressor limiter

DL231 OPERATORS MANUAL

LED BAR DISPLAY is a dual function facility which measures output level (input level if

The VU meter and threshold controls are calibrated to show 0VU at +4dB

ii.

In the gain reduction mode, all the red LED's are very slightly illuminated at all

times. This is quite normal and does not indicate a fault condition.

EXPANDER

THRESHOLD

RATIO

ATTENUATION

FUNCTION

ATTACK

RELEASE

VISUAL DISPLAY

STEREO LINK

SIDE-CHAIN EQ

bypass is selected) or gain-reduction, selectable by the display

switch.

(+10 to -40 dB) sets the point at which gain reduction takes place.

Signals above threshold pass un-attenuated unless compression

occurs..

A three position switch selects ratios of 1:2, 1:5 or 1:20 provides

gating characteristics. Gating can be regarded as the opposite of

limiting.

(Attn) a three position switch sets the maximum attenuation of 10,

20 or 40dB.

selects 'side-chain listen', normal (expander in operation) and off

(expander bypassed).

time is completely automatic. See introduction.

time is semi-automatic, matched to the compressor release and is

adjustable via the compressor release

is by means of three LED's arranged in a horizontal 'traffic light'

configuration. Green indicates zero expansion, whilst yellow shows

gain reduction of 50%, referring to the attenuated setting and red

100%.

couples the control circuits of both compressors to prevent image

shifting when treating stereo material on a final mix. The peak

limiters can also be used if desired but they remain independent.

Operational controls should be set the same on both channels when

linked.

may be applied to expanders and compressors via insert points at

the rear of the unit. Connection are via stereo jack ( Rind - send. Tip

- return)