- ページ 24

オーブン Bosch 8 SeriesのPDF ユーザーマニュアルと設置手順をオンラインで閲覧またはダウンロードできます。Bosch 8 Series 44 ページ。 Combi steam oven
Bosch 8 Series にも: 取付説明書 (21 ページ), 組み立て説明書 (4 ページ), 取付・使用説明書 (16 ページ), クイック・リファレンス・マニュアル (2 ページ), はじめに (7 ページ), 取扱説明書 (32 ページ), ユーザーマニュアルと設置手順 (32 ページ), 取扱説明書 (12 ページ), ユーザーマニュアルと設置手順 (24 ページ), ユーザーマニュアル (28 ページ), ユーザーマニュアルと設置手順 (28 ページ), 取付・使用説明書 (20 ページ), ユーザーマニュアルと設置手順 (44 ページ), 取扱説明書 (12 ページ), ユーザーマニュアルと設置手順 (40 ページ), ユーザーマニュアルと設置手順 (32 ページ), ご利用案内 (20 ページ), 取扱説明書 (48 ページ)

Bosch 8 Series ユーザーマニュアルと設置手順
en Cleaning assistance
18  Cleaning assistance
The cleaning assistance is a quick alternative for occa-
sionally cleaning the cooking compartment. The clean-
ing assistance softens dirt by vaporising the soapy wa-
ter. It is then easier to remove dirt.
18.1 Setting the cleaning assistance
WARNING ‒ Risk of scalding!
If there is water in the cooking compartment when it is
hot, this may create hot steam.
Never pour water into the cooking compartment
when the cooking compartment is hot.
Requirement: The cooking compartment has cooled
down completely.
Remove the accessories from the cooking compart-
1.
ment.
Mix 0.4 litres water with a drop of washing-up liquid
2.
and pour into the centre of the cooking compart-
ment floor.
Do not use distilled water.
Select the "Types of heating" operating mode.
3.
Set the bottom heating
4.
Use the control ring to set the temperature to
5.
80 °C.
Press "Cooking time".
6.
Use the control ring to set the cooking time to
7.
four minutes.
Press ​ ⁠ to start.
8.
19  Descaling
To ensure that your appliance continues to operate cor-
rectly, it must be descaled regularly.
How frequently you need to run the descaling pro-
gramme will depend on the water hardness and how
many times you have used the steam function. The ap-
pliance indicates when only another five or fewer
steam-assisted operations are possible. If you do not
carry out the descaling, you can no longer set any op-
eration with steam.
Descaling comprises several steps and takes approx.
70–95 minutes:
¡ Descaling (approx. 55–70 minutes)
¡ First rinse cycle (approx. 9–12 minutes)
¡ Second rinse cycle (approx. 9–12 minutes)
For reasons of hygiene, the descaling programme must
be run in full.
If descaling is interrupted, you can no longer set any
operation. To ensure that the appliance is ready for op-
eration again, carry out two rinse cycles.
19.1 Preparing descaling
ATTENTION!
The length of time for which the descaler is left to work
is based on the recommended, liquid descaler. Other
descalers may damage the appliance.
Only use the liquid descaler recommended by us
for the descaling programme.
24
​ ⁠ type of heating.
a The appliance starts to heat and the cooking time
counts down.
a When the time has elapsed, a signal sounds. The
time shown in the display is zero.
Use
​ ⁠ to switch the appliance off and leave the
9.
cooking compartment to cool for approx.
20 minutes.
18.2 Wiping down the cooking compartment
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
After using the cleaning assistance, wipe the cook-
ing compartment and allow it to dry completely.
Requirement: The cooking compartment must have
cooled down.
Open the appliance door and remove the remaining
1.
water with an absorbent sponge cloth.
Clean the smooth surfaces in the cooking compart-
2.
ment with a dish cloth or a soft brush. Remove stub-
born food remnants using a stainless steel scouring
pad.
Remove limescale with a cloth soaked in vinegar.
3.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
In order to dry the cooking compartment, leave the
4.
appliance door open in the detent position (approx.
30°) for approx. one hour.
If descaling solution comes into contact with the control
panel or other delicate surfaces, it will damage them.
Remove descaling solution immediately with water.
Mix the descaling solution:
1.
200 ml liquid descaler
400 ml water
Open the control panel.
2.
Remove the water tank and pour the descaling solu-
3.
tion into it.
Once the descaling solution has been poured into
4.
the water tank, slide the tank back in.
Close the control panel.
5.
19.2 Setting the descaling
Requirement: → "Preparing descaling", Page 24
Press
​ ⁠ .
1.
Press "Cleaning".
2.
Press "Descaling".
3.
a The duration appears in the display. The duration
cannot be changed.
Press ​ ⁠ to start.
4.
a The descaling programme starts and the duration
counts down.
a Once the first part of the descaling programme has
finished, an audible signal sounds. The appliance
prompts you to rinse twice.
To rinse the appliance, for each rinse cycle:
5.