en Cleaning and servicing
Basic setting
Fan run-on time
Pull-out system
Sabbath mode
Factory setting
1
Factory setting (may vary according to model)
13.2 Changing the basic settings
Requirement: The appliance is switched off.
Press and hold for approx. three seconds.
1.
Press
to confirm the messages in the display.
2.
a The first basic setting is shown in the display.
Use the control ring to change the basic setting.
3.
14 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
14.1 Cleaning products
In order to avoid damaging the various oven surfaces
on the appliance, do not use unsuitable cleaning
products.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Do not use harsh or abrasive cleaning products.
▶
Suitable cleaning agents
Only use cleaning agents that are suitable for the differ-
ent surfaces on your appliance.
Appliance front
Surface
Suitable cleaning agents Information
Stainless steel
¡ Hot soapy water
¡ Special stainless steel
Plastic or painted
¡ Hot soapy water
surfaces
E.g. control panel
14
Selection
1
Recommended
Minimum
Not retrofitted (if shelf sup-
ports and a single set of
pull-out rails are fitted)
Retrofitted (if two or three
sets of pull-out rails are fit-
ted)
Switched on
1
Switched off
Reset
1
Do not reset
cleaning products
suitable for hot sur-
faces
Press
4.
a The next basic setting appears in the display.
Use to scroll through the basic settings and, if re-
5.
quired, use the control ring to change any of these
settings.
To save the changes, press and hold for approx.
6.
1
three seconds.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
Discarding changes to the basic settings
Press
▶
a All changes will be discarded and not saved.
13.3 Setting the time
Requirement: The appliance is switched off.
Press and hold for approx. three seconds.
1.
Press
2.
a The first basic setting is shown in the display.
Press
3.
a The "Time" basic setting is shown in the display.
4.
Use the control ring to change the time.
To save the change, press and hold for approx.
5.
three seconds.
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Using oven cleaner in a hot cooking compartment
damages the enamel.
Never use oven cleaner in the cooking compartment
▶
when it is still warm.
Remove all food remnants from the cooking com-
▶
partment and the appliance door before you next
heat up the appliance.
New sponge cloths contain residues from production.
Wash new sponge cloths thoroughly before use.
▶
Follow the instructions on cleaning the appliance.
→ "Cleaning the appliance", Page 15
To prevent corrosion, remove any limescale, grease, starch or albu-
min (e.g. egg white) stains on stainless steel fronts immediately.
Apply a thin layer of the stainless steel cleaning product with a soft
cloth.
Do not use glass cleaner or a glass scraper.
To avoid permanent stains, remove any descaling agent that gets
onto the surface immediately.
.
.
to confirm the messages in the display.
.
ページを印刷する