- ページ 5
計測機器 BD Diesel Performance X-Monitor 1085000のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。BD Diesel Performance X-Monitor 1085000 13 ページ。 Digital pyro & boost pressure monitor
ページを印刷する6 November 2006
Thermocouple Wiring
Route the thermocouple wire towards the firewall, taking precaution to keep it away
from hot and moving parts, and then pass it through the firewall by piercing a large
rubber grommet in the firewall beside the brake booster canister.
NOTE: Do NOT cut or splice the thermocouple lead wire, as it is special wire
that provides correct reading to the gauge. Simply coil any excess wire out of
the way.
From under the dash, route the thermocouple to the X-Monitor Control Module.
Install the wires onto the control module as shown in the diagram.
CAUTION: DO NOT MIX UP THESE WIRES, ENSURE YELLOW TO YELLOW
AND RED TO RED OR DAMAGE WILL RESULT AND WARRANTY WILL BE
VOIDED.
Boost Pressure Sender
Ship: 88 – 446 Harrison St, Sumas, WA 98295
BD X-Monitor (Pyro & Boost Only)
Duramax (Non LLY)
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
Locate the turbo wastegate
hose and follow it along to
the plenum.
Remove
wastegate from the barb
fitting on the plenum and
install the rubber hose end
of the supplied boost fitting
assembly onto the barb.
Install the turbo wastegate
onto
supplied
assembly.
Mail: PO Box 231, Sumas, WA 98295
the
turbo
the
barb
of
boost
fitting
5
the