- ページ 7

ページを印刷する

WARNING

Avoid Scalding or Electrical Shock Hazard!

Make sure the water supply and electrical supply

are shut off before installation or service.

NOTE: This dishwasher is designed to be enclosed on the

top and both sides by standard residential kitchen cabinetry.

Select a location as close to the sink as possible for easy

access to water supply and drain lines.

For proper dishwasher operation and appearance, ensure

that the enclosure is square and has the dimensions shown

in Figure 1 below.

Figure 1

NOTE: If your dishwasher opening width measures

>18" (458mm) use the TOP mounting method.

If your dishwasher opening width measures 18"(458mm)

use the SIDE MOUNT mounting method.

If the dishwasher is to be installed in a corner, make sure that

there is adequate clearance to open the door. See Figure

2 below.

Check clearance

between

dishwasher door

and wall

Figure 2

WARNING

Avoid Electrical Shock/Fire Hazard

Do not allow the electrical and water supply lines

Enclosure Requirements

90°

Countertop

to touch.

After locating the proper place for your new dishwasher,

you will need to create any required openings to allow for

passage of the water, drain and electrical line. In order to

avoid interference with the dishwasher when sliding it into the

cabinet, place your openings within the dimensions shown

in Figure 3 below.

Figure 3

Required Openings:

1 1/2" (38 mm) diameter- To pass the included electrical

supply junction box through to adjacent cabinet. The edges

of the opening should, if the partition is wood, be smooth

and rounded or, if the partition is metal, be covered with the

grommet (I) provided for this purpose by the manufacturer.

Note: If the incoming electric supply, water supply and drain

connections are all in the same cabinet, the one 4

hole will be large enough for all three to pass

(120 x 60 mm)

through.

4" x 2"

- To pass the included water supply line

(100 x 50 mm)

toward the water supply

diameter - To pass the dishwasher drain hose

(32 mm)

toward the drain connection

Before sliding the dishwasher into the cabinet, remove the

hose clip at the back of the dishwasher as shown in Figure

4. The hose clip may be used later to hold the drain hose as

shown in Figure 8.

Figure 4

(114mm)

(64mm)

" x 2