- ページ 11
オーブン Bosch Benchmark 500 SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Bosch Benchmark 500 Series 39 ページ。 Built-in combination ovens
Bosch Benchmark 500 Series にも： インストレーション・マニュアル (22 ページ)
ページを印刷する
Combination Oven Pre-Assembly
Removing Packaging
1. Cut straps on the outside of the boxes.
2. Remove the upper boxed unit of the combination oven.
3. Perform the following steps on both units of the
combination oven.
a. Remove the cardboard box by lifting it up and off
the unit.
b. Remove all top and side cardboard and foam
braces.
c. Place the unit (leaving it on the shipping base) in
front of the cabinet where it is to be installed.
d. Remove all accessories, racks, packing materials,
and literature from the oven cavities.
e. Unscrew unit from packaging brackets as shown in
"Packaging Bracket Removal."
Note: The screws near the base mounting bracket of
each unit are all star-head (T-20 size). Only the one
screw that goes through the slotted hole in the
mounting bracket on the left and right sides of the unit
needs to be removed in order to lift the unit from the
mounting base (the screw circled and shown as "A" in
the following illustration.)
NOTICE
Remove one screw only from each bracket. This
will release the oven from the shipping base. Do
not remove any additional screws from the oven.
Packaging Bracket Removal (left and
right sides)
Note:
Actual brackets may look differently. The bracket remains
in the packaging base. The unit should stay on the
packaging base until ready to be lifted into cabinet cutout or
onto the lower oven.
English 6
Preparing Ovens
Place ovens in front of the cabinet where it is to be installed
so that they are in line with the cabinet cutout.
Check to be sure all packing materials have been removed
from the unit. Also remove the accessories, oven racks,
literature pack and any shipping materials from inside the
oven cavity (remove from both cavities for a double oven or
combination oven).
9001080875 Rev A