- ページ 14
オーブン Bosch Benchmark HBL5751UCC/03のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Bosch Benchmark HBL5751UCC/03 39 ページ。 Built-in combination ovens
ページを印刷する
Note: The universal connector brackets are interchange-
able for the left and right sides of the oven. Be sure the
taller vertical edge of the bracket is positioned to the out-
side of the oven.
5. Install the decorative trim.
Position the decorative trim
piece so the flanges with
the holes in them face to
the rear of the oven.
Align the inner flanges with
the inside of the universal
brackets. Fasten with one
screw each into the end
hole of the universal
bracket. Tighten screws
securely, but do not
overtighten.
6. Place the steam convection oven unit on top of the
universal connector brackets and fasten in place using
two screws per side. Tighten the screws securely, but
do not overtighten.
Note: The existing screws in the steam convection
oven base help with alignment. When lowering the
9001080875 Rev A
steam convection oven into place on the universal
connector brackets, allow these screw heads to slide
into the slots as shown in the illustration below. The
screw nearest the front of the steam convection oven
should slide into the base of the slope at the front of the
bracket.
7. Continue to "Connecting the Speed Microwave Oven or
Steam Convection Oven Electrical Conduit to the
Lower Oven".
Connecting the Speed Microwave Oven
or Steam Convection Oven Electrical
Conduit to the Lower Oven
Note: When installing the combination unit, the speed
microwave oven or steam convection oven power cable
must be properly attached to the oven-mounted junction
box. This must be done prior to supplying electric power to
the oven unit.
9 WARNING
Check to be sure that no electric power has yet
been supplied to the oven.
1. Remove the oven-mounted junction box cover (located
on the rear top of the oven - at arrow in the following
illustration).
English 9