- ページ 28

オーブン Bosch Benchmark SeriesのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Bosch Benchmark Series 36 ページ。 Built-in wall ovens
Bosch Benchmark Series にも：インストレーション・マニュアル (32 ページ), クイック・リファレンス・マニュアル (4 ページ), サービスマニュアル (45 ページ), 取付説明書 (40 ページ), クイック・スタートと安全マニュアル (13 ページ)

ページを印刷する

58300000187895 ARA EN A

4. Disconnect the two wires from the element terminals.

5. Follow the steps in the Removing the Drawer Assembly from

Housing section.

6. Remove the two screws securing the element to the rear.

7. Grasp the element on both sides and pull it straight out of the

cavity.

8. Install the new element.

9. Follow the steps in the Replacing the Drawer Assembly in

Housing section.

10. Connect the wires to the element terminals in the rear.

11. Restore power and test operation.

12. Reinstall the wire cover.

13. Slide the range back into place, being sure to properly engage

the anti-tip bracket.

9.4

Repairing a Drawer that Binds

On some units, the warming drawer may bind and not open or close

properly. Installing an additional support bracket on each side of the

drawer may resolve this issue on units which were not built with the

brackets.

For additional information and installation instructions, see the bulletin

linked to Warming Drawer Bracket kit 00634014 in QuickFinder.

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

MAY 2015

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch Benchmark Series Induction Slide-in Ranges

Page 28 of 36

800 944-2904