- ページ 24
オーブン Bosch CBG633N 1 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch CBG633N 1 Series 48 ページ。
ページを印刷する
Trouble shooting
en
Fitting the door on the appliance
Insert the front panel at the bottom into the retainers
1.
(figure
).
!
Close the front panel until both upper hooks are
2.
opposite the opening (figure
Press the front panel at the bottom until it clicks
3.
audibly into place (figure
Open the appliance door again slightly and remove
4.
the tea towel.
Screw both screws back in on the left and right.
5.
Put the cover back in place and press on it until it
6.
clicks audibly into place (figure
Fault
The appliance does not work.
"Sprache Deutsch" appears on the
display.
The time does not appear when the
appliance is switched off.
The appliance does not heat up; the
m symbol lights up on the display.
The appliance will not start and
"Cooking compartment too hot"
appears on the display
The rotary selector has fallen out of
the support in the control panel.
The rotary selector can no longer be
turned easily.
--------
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
When an error message appears on the display with "D"
or "E", e.g. D0111 or E0111, switch the appliance off
and on again using the ÿ On/Off button.
24
).
"
)
#
).
$
Possible cause
Faulty fuse.
Power cut
Power cut
Basic setting is changed.
Demo mode is activated in the
basic settings.
The cooking compartment is
too hot for the selected dish
or type of heating
The rotary selector has been
accidentally disengaged.
There is dirt under the rotary
selector.
Close the appliance door.
7.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
Notes/remedy
Check the circuit breaker in the fuse box.
Check whether the kitchen light or other kitchen appliances are working.
Reset the language and the time.
Change the basic setting for the clock display.
Briefly disconnect the appliance from the mains (switch off the circuit breaker
in the fuse box) and then deactivate demo mode in the basic settings within 3
minutes.
Allow the cooking compartment to cool down and start again
The rotary selector can be removed. Simply place the rotary selector back in
its support in the control panel and push it in so that it engages and can be
turned as usual.
The rotary selector can be removed. To disengage the rotary selector, simply
remove it from the support. Alternatively, press on the outer edge of the rotary
selector so that it tips and can be picked up easily.
Carefully clean the rotary selector and its support on the appliance using a
cloth and soapy water. Dry with a soft cloth. Do not use any sharp or abrasive
materials. Do not soak or clean in the dishwasher.
Do not remove the rotary selector too often so that the support remains sta-
ble.
If it was a one-off error, the display goes out. If the error
message appears again, call the after-sales service and
quote the exact error message.