- ページ 26
オーブン Bosch CBG934A 1 SeriesのPDF ユーザーマニュアルと設置手順をオンラインで閲覧またはダウンロードできます。Bosch CBG934A 1 Series 40 ページ。
ページを印刷するen Troubleshooting
Guide the rail lengthways to the rear to the guide
2.
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer
tical rod.
Press and hold PUSH
3.
inwards
until the retainer
lower rod.
a
20 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
20.1 Malfunctions
Fault
The appliance is not
working.
"Sprache Deutsch"
appears in the dis-
play.
26
to grip the ver-
and swing the pull-out rail
is attached in the
Cause and troubleshooting
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
Electronics fault
Disconnect the appliance from the power supply for at least 30 seconds by switching off
1.
the fuse.
Reset the basic settings to the factory settings.
2.
→ "Basic settings", Page 15
There has been a power cut.
Configure the initial configuration settings.
▶
→ "Performing initial start-up", Page 10
Release the PUSH tab.
4.
a The retainer clicks into place.
Pull the pull-out rail out as far as it will go and slide
5.
it back in.
Note:
Further information:
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced by trained specialist staff.