- ページ 34
オーブン Bosch CDG634A 0 SeriesのPDF ユーザーマニュアルと設置手順をオンラインで閲覧またはダウンロードできます。Bosch CDG634A 0 Series 40 ページ。
Bosch CDG634A 0 Series にも： 取扱説明書 (36 ページ)
ページを印刷するen Installation instructions
WARNING ‒ Danger: Magnetism!
Permanent magnets are used in the control
panel or in the controls. They may affect elec-
tronic implants, e.g. pacemakers or insulin
pumps.
▶ Wearers of electronic implants must stay at
least 10 cm away from the control panel or
controls during the installation.
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use multiple socket strips.
▶ Only use extension cables that are certified,
have a minimum cross section of 1.5 mm²
and comply with the applicable national
safety requirements.
▶ If the power cord is too short, contact cus-
tomer service.
▶ Only use adapters approved by the manu-
facturer.
ATTENTION!
Carrying the appliance by the door handle
could break it. The door handle cannot sup-
port the weight of the appliance.
▶ Do not carry or hold the appliance by the
door handle.
17.4 Installation underneath a hob
If the appliance is installed under a hob, the following
minimum dimensions must be adhered to (including
substructure, if applicable).
Hob type
Induction hob
34
a raised in mm
42
17.2 Appliance dimensions
You will find the dimensions of the appliance here
17.3 Installation below a worktop
Observe the installation dimensions and the installation
instructions when installing below a worktop.
¡ To ventilate the appliance, the intermediate floor
must have a ventilation cut-out.
¡ The worktop must be secured to the built-in unit.
¡ Observe any available installation instructions for the
hob.
The minimum worktop thickness
required minimum clearance
a flush in mm
43
a is based on the
.
b in mm
5