- ページ 14
オーブン Bosch CMG7241B1AのPDF ユーザーマニュアルと設置手順をオンラインで閲覧またはダウンロードできます。Bosch CMG7241B1A 44 ページ。
ページを印刷するen Time-setting options
8.8 Sabbath-compliant use
If you want to operate your appliance so that it is Sab-
bath-compliant, use the time-setting options and
change the basic setting for the lighting.
Note: If you open the appliance door during operation,
the appliance stops heating. When you close the appli-
ance door, the appliance continues to heat again. To
operate your appliance so that it is Sabbath-compliant,
do not open the appliance door until after operation.
Change the "Lighting" basic setting to "Always off".
1.
→ "Basic settings", Page 19
This will ensure that the light in the cooking com-
partment is always off while the appliance is in oper-
ation and when you open the appliance door.
Set the required operating mode.
2.
→ "Setting the operating mode", Page 13
→ "Setting the type of heating and the temperature",
Page 13
Set the required cooking time depending on the op-
3.
erating mode.
→ "Setting the cooking time", Page 14
9 Time-setting options
For an operation, you can set the cooking time and the
time at which the operation should be finished. The
timer runs independently of the operation.
Time-setting
Use
option
Cooking time
If you set a cooking time, the appli-
ance stops heating automatically
once this time has elapsed.
End time
Along with the cooking time, you can
set the time at which you want the
operation to end. The appliance
starts up automatically so that the
operation finishes at the required
time.
Timer
You can set the timer to run inde-
pendently of the appliance during op-
eration. It does not affect the appli-
ance.
9.1 Setting the cooking time
You can set the cooking time for the operation up to
24 hours.
Requirement: An operating mode and temperature or
level have been set.
Press
"Cooking time".
1.
To set the cooking time, press the relevant time
2.
value, e.g. hour display "h" or minute display "m".
a The selected value is marked in blue.
Use the setting ring to set the cooking time.
3.
If required, use
to reset the setting value.
To confirm the set cooking time, press
4.
play.
Press
to start the operation.
5.
a The appliance starts to heat and the time counts
down.
14
→ "Time-setting options", Page 14
Use "End time" to set the time at which the opera-
4.
tion should end.
→ "Setting the end time", Page 14
→ "Time-setting options", Page 14
Place the food in the cooking compartment before
5.
the appliance starts to heat.
Press
6.
a The display shows the time remaining until the oper-
ation starts. The appliance is in standby mode.
a Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
When the operation has ended, remove the food
7.
from the cooking compartment. The appliance auto-
matically switches off completely after approximately
15 to 20 minutes.
Note: If necessary, change the basic setting for the
lighting again.
a When the time has elapsed, a signal sounds. A
message appears on the display confirming that the
operation has finished.
Once the cooking time has elapsed:
6.
‒
‒
Changing the cooking time
You can change the cooking time at any time.
Press
1.
Press the cooking time
2.
Use the setting ring to change the cooking time.
3.
To confirm the change, press
4.
a The change is applied.
Cancelling the cooking time
You can cancel the cooking time at any time.
Press
1.
Press the cooking time
2.
Reset the cooking time using
3.
Note: For operating modes that always require a
cooking time, the appliance resets the cooking time
to the preset value.
To confirm the change, press
4.
a The change is applied.
9.2 Setting the end time
You can delay the time at which the cooking time for
the operation is due to end by up to 24 hours.
Notes
on the dis-
¡ To achieve good cooking results, do not delay the
time once the operation has already started.
¡ Food will spoil if you leave it in the cooking com-
partment for too long.
to start the operation.
If required, you can select other settings and re-
start the operation.
When the food is ready, use
pliance off.
on the display.
.
on the display.
.
to switch the ap-
on the display.
.
on the display.