Safety Warning and Precautions
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible
conditions or situations that could occur. It must be understood by the operator that common sense
and caution are factors that cannot be built into this product, but must be supplied by the operator.
1. Keep the work area clean and dry. Damp or wet work areas can result in injury.
2. Keep children away from work area. Do not allow children to handle this product.
3. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger industrial equipment.
There are certain applications for which this equipment was designed. It will do the job better and more safely at
the capacity for which it was intended. Do not modify this equipment, and do not use this equipment for a purpose
for which it Was not intended.
4. Check for damaged parts. Before using this product, carefully check that it will operate properly and perform its
intended function. Check for damaged parts and any other conditions that may affect the operation of this product.
Replace damaged or worn parts immediately.
5. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury, etc.
6. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating this equipment may result in serious personal injury.
Product Specific Safety Precautions
When the pump is connected to the compressed air supply:
1. The compressed air must be filtered to avoid dust and moisture entering the pump.
2. The maximum compressed air pressure must not exceed 1.0Mpa/150psi.
3. To deliver oil open the tap, delivery stops when the tap is closed but the whole system remains under pressure.
4. Always cut off the air supply after use so that oil can't leak out in case one of the pump's components should break.
5. Use only original spare parts in case the pump has to be repaired or its components have to be replaced.
6. Empty all the oil from the pump in case it has to be disposed of.
7. When not in use, turn off compressed air to stop the pump.
8. Do not use the pump near open flames. Do not smoke during this operation.
9. Wear oil-proof gloves.
10. Do not throw the oil away. Used oil has to be disposed of according to national environmental regulations.
11. The pump can be used only to deliver lubricants, used oil or antifreeze liquids.
Do not use the pump for any other substance.
Read the following precautions and instructions before you begin assembly or using.
Failure to comply with these instructions could result in personal injury or property damage.
Keep these instructions in a convenient location for future reference.
Important Notes
• The guarantee will be void if the pump has been altered in any way.
• It is recommended that a filter, regulator and lubricator should always be used to maximise the working life of the
pump, our product O300160 is ideal for this pump.
• Please use PTFE tape or thread sealant when connecting the hose to the outlet of the pump.
NSW/ACT
QLD/PNG
TEL: (02) 9677 1555
TEL: (07) 3204 9166
FAX: (02) 9675 1155
FAX: (07) 3204 1224
OWNER'S TECHNICAL MANUAL
5:1 Air-operated Oil Pump
VIC/TAS
TEL: (03) 8787 8288
FAX: (03) 8787 8266
Visit our website at
www.alemlube.com.au
WA
SA/NT
TEL: (08) 9302 4199
TEL: (08) 8241 7111
FAX: (08) 9303 2095
FAX: (08) 8241 7011
or
www.alemlube.co.nz
O300140
NZ
TEL: (09) 447 1007
FAX: (09) 447 1008
2
ページを印刷する