- ページ 5

オーブン Bosch Evolution HDS7052UのPDF 変換マニュアルをオンラインで閲覧またはダウンロードできます。Bosch Evolution HDS7052U 32 ページ。 Dual fual ranges
Bosch Evolution HDS7052U にも：取付説明書 (36 ページ)

ページを印刷する

Convert Pressure Regu-

lator from 5" W.C. to 10"

W.C.

Replace Cooktop Orifices

1. Remove Warming Drawer; Pull drawer out until stop is reached. Facing the

range, push clip on left side up and clip on right side down. Pull drawer the

rest of the way out.

2. Remove cover plate from interior back wall by removing single screw on left

side of panel. Use a torx T-20 head screwdriver.

3. Remove the hexagon cap from the top of the regulator with an adjustable

wrench.

4. Pop out the plastic stem in the cap and turn it over pressing it firmly in place

so that the letters "LP" (rather than "NAT") are seen upright in the stem.

5. Replace the cap and button assembly into the top of the regulator sealing it

firmly. Make certain spring is still in place (See Fig. 1). DO NOT OVER

TIGHTEN.

7. Fill out and affix the CONVERSION STICKER on the back side of the cover

plate so that it appears on the back side of range next to the regulator.

1. Remove Grates, Burner Caps and Burner Bases.

Unscrew two (2) T20 screws inside each base and remove burner bases.

Reinsert screws in jet holder to hold tubing assembly in place.

Burner Grate

Burner Cap

Burner Base

Orifice

3. Remove Natural Gas Cooktop Orifices.

Insert the socket driver with 3" minimum extension into the jet holders to

remove existing orifices. Set natural gas orficies aside.

4. Assemble LP Cooktop Orifices.

Place in cooktop exactly as laid out in the orifice card. If the orifices become

separated from the card, placement can be determined by matching the num-

ber and/or color on the orifice with the placement specifications displayed in

the chart on the card

Pin Position

for Propane

Hex

Cap

Position

for Nat.

Gas

Hex

Spring

Cap

NAT

Conversion

Figure 6: Pressure Regulator

Ignitor

Figure 2: Cooktop Orifice

English 3