- ページ 6

ページを印刷する

Installation Procedure

9 CAUTION

Before installing, turn power OFF at the service

panel. Lock service panel to prevent power from

being turned ON accidentally.

Installing with Microwave or Steam

Oven

Pre-Assembly Preparation

Mounting the microwave or steam oven on the warming

drawer requires the units to be assembled together prior to

installing into the cabinet cutout.

Note:

The parts contained in the square tube parts box are

common to both installations.

Parts Provided

Universal connector

bracket (2)

(in parts box)

Screws (12)

(in red bag, inside parts

box)

1. Prepare cabinet cutout.

Prepare cabinet cutout and install electrical connection

according to the dimensions in "General Information".

2. Remove the drawer from the drawer housing.

a. Pull drawer to fully open position.

b. Press down right drawer release lever.

c. Lift up left drawer release lever.

d. Firmly pull the drawer straight out.

Retract cabinet rails while drawer is removed.

English 4

3. Position the warming drawer housing in front of the

cabinet where it is to be installed. Position the

Microwave or Steam Oven nearby.

4. The warming drawer is ready for the Microwave or

Steam oven to be mounted on it.

Mounting the Microwave on the Warming

Drawer

Assemble the Brackets to the Warming Drawer

Note: Do not place the warming drawer into the wall

cabinet until after mounting the microwave on it using the

universal connector brackets.

1. Attach both universal connector brackets to the

warming drawer housing using three of the screws

provided for each bracket. Tighten screws securely,

but do not overtighten.

Note: The universal connector brackets are interchange-

able for the left and right sides of the warming drawer. Be

sure the taller vertical edge of the bracket is positioned to

the outside of the warming drawer.