- ページ 9
リモコン AirStage UTY-DCGYのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。AirStage UTY-DCGY 11 ページ。 Central remote controller
AirStage UTY-DCGY にも： インストレーション・マニュアル (9 ページ)
ページを印刷する(7)
Fix the holder 1 assembly (2 places) with
screws (2 pcs x 2 places).
Power unit cover
B. Controller body wiring
(1)
Pull around the transmission cable as shown in
the figure, and connect it to the terminal of the
rear panel.
(2)
Pull around the extension cable as shown in the
figure, and connect it to the terminal of the rear
panel. And fix with binder firmly.
Transmission cable
Extension cable
Transmission cable
Binder
(accessory)
Holder
(accessory)
Screw×4
(When fixing the
Holder, remove the 4
screws in advance.)
Screw×4
(Accessories)
Extension cable
(service parts)
+5V
GND
X1
X2
Terminal connection
(3)
Install the rear panel to a wall.
Transmission cable
Screw ×4
(accessories)
(4)
Cut the thin part (gray marked part) at the top of
the front panel with a cutter.
When passing the cable through the rear hole, do not cut off
Ì
the thin part at the top.
(5)
Connect the connection cable connector to the
connector (CN13) of the front panel PC board.
(6)
Install the front panel to the rear panel.
CN13
*
When installing the front panel to the rear panel, install it care-
fully so that the cable is not pinched or the parts of the circuit
board are not pushed by things projecting from the rear panel.
The circuit board parts may be damaged.
Extension cable
Cutting out
En-8