- ページ 5

洗濯機 Electrolux 400 SERIESのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Electrolux 400 SERIES 50 ページ。 Front load dryer
Electrolux 400 SERIES にも：取扱説明書 (16 ページ), 取扱説明書 (39 ページ), 取扱説明書 (28 ページ), 取扱説明書 (46 ページ)

ページを印刷する

Electrical system

requirements

CIRCUIT - Individual, properly polarized

and grounded 15 amp. branch circuit

fused with 15 amp. time delay fuse or

circuit breaker.

POWER SUPPLY - 2 wire, with ground,

120 volt single phase, 60 Hz, Alternating

Current.

NOTE

Because of potentially inconsistent voltage

capabilities, the use of this washer with

power created by gas powered generators,

solar powered generators, wind powered

generators or any other generator other

than the local utility company is not rec-

ommended.

OUTLET RECEPTACLE - Properly

grounded 3-prong receptacle to be

located so the power supply cord is

accessible when the washer is in an

installed position.

WARNING

Improper grounding of the washer may

cause serious injury or death. Check with a

licensed electrician if you are in doubt as to

whether the appliance is properly grounded.

Grounding type wall receptacle

Do not, under

any circumstances,

cut, remove,

or bypass the

grounding prong.

Power cord with

3-prong grounded plug

Grounding requirements

1. The washer MUST be grounded. In

the event of malfunction or break-

down, grounding will reduce the risk

of electrical shock by a path of least

resistance for electrical current.

Installation Requirements

Improper connection of the equipment

grounding conductor can result in a risk

of electrical shock. Check with a licensed

electrician if you are in doubt as to wheth-

er the appliance is properly grounded.

2. Since your washer is equipped with

Water supply

requirements

Hot and cold water faucets MUST be in-

stalled within hose length of your washer's

water inlet. The faucets MUST be 3/4 inch

(1.9 cm) with threading for laundry hose

connection. Water pressure MUST be be-

tween 20 and 120 psi. Pressure difference

between hot and cold cannot be more

than 10 psi. Your water department can

advise you of your water pressure.

Drain system

requirements

1. Drain capable of eliminating 17 gals

2. A standpipe diameter of 1-1/4 in. (3.18

3. The standpipe height above the floor :

WARNING

ELECTRICAL SHOCK HAZARD

a power supply cord having an

equipment-grounding conductor and

a grounding plug, the plug MUST be

plugged into an appropriate, cop-

per wired receptacle that is properly

installed and grounded in accordance

with all local codes and ordinances or

in the absence of local codes, with the

National Electrical Codes, ANSI/NFPA

70 (latest edition), or in Canada, the

Canadian electrical code C22.1 part 1.

If in doubt, call a licensed electrician.

DO NOT cut off or alter the grounding

prong on the power supply cord. In

situations where a two-slot receptacle

is present, it is the owner's responsibil-

ity to have a licensed electrician replace

it with a properly grounded three prong

grounding type receptacle.

(64.3 L) per minute.

cm) minimum.

Minimum height: 24 in. (61 cm)

Maximum height: 96 in. (244 cm).