The appliance is then ready for use:
•
Open the door.
•
Pour the required amount of detergent non-foaming
into the tank.
•
Insert the dirty items and containers upside down
on the basket.
•
Arrange items in the rack.
RIncrease / decrease the water pressure
For washing light items:
-
unscrew the wing nut "X" (Figure 19);
-
press the limiting valve "Y" (Figure 19) inward to
reduce the water pressure in the lower wash arm
and thus increase the water pressure in the upper
wash arm, so that the items remain in their position.
-
retighten the wing nut "X" (Figure 19).
For washing large and heavy items:
-
unscrew the wing nut "X" (Figure 19);
-
remove the limiting valve "Y" (Figure 19);
-
retighten the wing nut "X" (Figure 19).
Figure 19 Wash water pressure adjustment
•
Close the door and select the suitable wash cycle;
the corresponding indicator light comes on and the
wash cycle starts.
Usable wash cycles:
- Automatic cycle I
For lightly soiled items: press button "G" (see Table 2
"Control panel" and table of times).
- Automatic cycle II (recommended)
For normally dirty items: press button "H"(see Table 2
"Control panel" and table of times).
- Automatic cycle III
For very dirty items: press button "I" (see Table 2 "Con-
trol panel" and table of times).
- Manual cycle IV
For particularly heavy dirty items or for other specific
needs of the user: press button "L" (see Table 2 "Con-
trol panel"), which initiates a continuous wash until the
operator selects an automatic cycle.
X
Y
•
To stop the wash cycle, just press the selected cycle
button or open the door.
•
To continue the wash cycle, just press the selected
cycle button or close the door. The cycle starts
again from where it stopped.
•
At the end of the wash, the appliance emits a series
of beeps and "END" blinks on the display:
End
open the door and remove the basket containing
the clean items.
IMPORTANT
The use of "foaming"/non-specific detergents or in
any case detergents used in different ways from that
prescribed by the manufacturer, can cause damage
to the appliance and compromise washing results.
IMPORTANT
Failure to remove the residuals of detergent possibly
used for manual prewash can cause malfunctioning
of the appliance and compromise washing results.
Change the water in the tank at least twice a day.
Loading the racks provided
Figure 20 Basket for items
Figure 21 Tray rack
J7
Alarms
In case of a generic appliance fault, the display shows
the relevant alarm code.
27