- ページ 15
オーブン Bosch HBA63B2.1BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch HBA63B2.1B 28 ページ。 Avantixx built-in single multi-function activeclean oven brushed steel
Bosch HBA63B2.1B にも： 取扱説明書 (28 ページ)
ページを印刷する
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
Detach the oven door and lay it on a cloth with the handle
1.
facing down.
Unscrew the cover at the top of the oven door. To do this,
2.
undo the left and right screws (fig. A).
Lift the top panel up and out (fig. B).
3.
$
Unscrew the retaining clips on the right and left. Lift the panel
4.
and remove the brackets from the panel (fig. C). Take out the
panel.
&
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
Power cut
and zeros
0
light up in the
display.
The oven does
There is dust on
not heat up.
the contacts.
%
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left.
Insert the panel diagonally towards the back (fig. A).
1.
Stick the retaining clips onto the right and left-hand sides of
2.
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. B).
$
Insert the uppermost panel diagonally towards the back. The
3.
smooth surface must face outwards.
Put the cover back in place and screw it on.
4.
Attach the oven door.
5.
Do not use the oven again until the panels have been
correctly fitted.
Problem
Possible cause Remedy/information
The oven door
The oven door
cannot be
is locked by
opened. The
L
self-cleaning.
symbol lights
up in the dis-
play.
The oven does
The oven is in
not heat up. The
demonstration
colon in the dis-
mode.
play flashes.
F8 appears in
Automatic
the display.
switch-off has
been activated.
%
Wait until the oven has
q
cooled down and the
symbol goes out.
Switch off the circuit
breaker in the fuse box and
switch it on again after
approximately 20 seconds.
Now, within approx.
2 minutes, press and hold
the
button for approx.
D
4 seconds until the colon
lights up constinuously.
Turn the function selector to
the off position.
L
15