- ページ 18
洗濯機 Electrolux EFLS210TIWのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux EFLS210TIW 22 ページ。 Front load dryer
Electrolux EFLS210TIW にも： 取付説明書 (33 ページ)
ページを印刷する
18
Solutions to Common Problems
Avoid Service Checklist
Before calling for service, review this list. It may save both time and expense. The list includes
common occurrences that are not the result of defective workmanship or materials in this dryer.
OCCURRENCE POSSIBLE CAUSES
Dryer does not
start.
Dryer runs but
won't heat.
Drying cycle takes
too long, outside of
the dryer feels too
hot or smells hot.
Dryer stops
during a cycle and
EMPTY WATER
CONTAINER is lit
on console.
Excessive
wrinkling.
Scratching or
chipping of the
drum finish.
*Drum damage caused by foreign objects or permanently attached items is not covered by the
warranty.
• Electrical power cord is not
securely plugged in or plug
may be loose.
• House fuse blown or circuit
breaker tripped.
• There are 2 house fuses in
the dryer circuit. If 1 of the 2
fuses is blown, the drum may
turn but the heater will not
operate.
• Lint filter is clogged with lint.
• Electric dryer is connected to
a 208 volt circuit.
• Drying procedures have not
been followed.
• High humidity.
• Water tank was not emptied
between cycles and is full.
• Dryer is overloaded.
• Items left in dryer too long.
• Insufficient sorting of items.
• Drying temperature or
dryness level too high.
• Foreign objects such as
coins, pins, clips or buttons
are inside the dryer.*
• Permanently attached items
such as belt buckles, zippers
and fasteners may be hitting
the inside of the drum.*
SOLUTIONS
• Make sure the plug fits tightly in wall
outlet.
• Reset circuit breaker or replace fuse.
• Make sure electrical line is not
overloaded and the dryer is on a
separate circuit.
• Replace fuse.
• Make sure all lint has been removed
from the dryer lint filter before starting
each cycle.
• Drying time will be 20% longer than
drying on a 240 volt circuit.
• See "Operating Instructions".
• Use a dehumidifier near the dryer.
• Empty water tank and continue cycle.
• Do not overload. See "Operating
Instructions".
• Remove items as soon as cycle
ends.
• Use the extended tumble and wrinkle
release options if unable to remove
the load immediately.
• See "Operating Instructions".
• Follow fabric care label instructions.
• Always remove foreign objects from
pockets before laundering. Remove
objects from drum and restart dryer.
• It may be necessary to sew a
scrap of material securely around
ornaments before drying to prevent
scratching and damage to the dryer.