ページを印刷するPull out the metal rail on the right-hand side (figure B).
3.
Unscrew the screw on the right-hand side (figure C).
4.
%
Take hold of the panels on the left and right-hand side, tilt
5.
forward slightly and pull up and out (figure D). Place on a
cloth with the handle underneath. The inner panel with the
hooks remains fitted to the oven carriage.
Unscrew the retention clips on the right and left (figure E).
6.
Remove the panel and remove the clips for cleaning.
'
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. The
glass could be damaged.
Installation
During installation, make sure that the lettering "Right above" is
upside down at the bottom left of the panel.
Insert the panel diagonally towards the back (figure A).
1.
Fit the retention clips on the right and left, so that the clips are
2.
over the screw holes. Screw both clips tight again (figure B).
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out as well as you had hoped, refer to
the section Tested for you in our cooking studio, where you will
find plenty of cooking tips and notes.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
&
(
Look in the fuse box and
check that the circuit
breaker is in working order.
$
Insert the panel into the retainer on the oven carriage.
3.
Screw the right-hand screw back in until it is flush (figure C).
4.
Do not tighten completely.
Slide the metal rail with hook in again (figure D).
5.
&
Put the cover back in place and screw it on. If it is not
6.
possible to screw on the cover, check whether the panels are
correctly seated in the retainer.
To ensure that the door panel is centrally positioned, use the
7.
screw to align by turning it slightly to the right or left
(figure E).
(
Close the oven carriage.
8.
Do not use the oven again until the panels have been
correctly fitted.
Problem
Possible cause Remedy/information
Power cut
Power cut
and zeros
0
flash in the dis-
play.
The oven does
There is dust on
not heat up.
the contacts.
%
'
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
13