- ページ 2

スイッチ Draytek Vigor 3300 SeriesのPDF クイック・スタート・マニュアルと安全に関する推奨事項をオンラインで閲覧またはダウンロードできます。Draytek Vigor 3300 Series 4 ページ。 Broadband voip / security / load balancer router
Draytek Vigor 3300 Series にも：パンフレット＆スペック (4 ページ), 適合宣言 (1 ページ), トラブルシューティングマニュアル (12 ページ)

ページを印刷する

2. Basic Setup

2.1 Start Your Configuration

Check your PC's IP address to see if it is on the subnet, to

which the router's LAN IP address belongs.

2.3 Login

A screen will show up asking for your User Name and

Password. Enter the user name and password in the

respective fields, and then click OK. The default user name

is draytek and password is 1234.

2.5 WAN Connection Mode Setting

2.6 Set LAN Connection

2.2 Access the Web-based Utility

To do the basic configuration, open the Web browser (e.g. IE

or Netscape). Enter the router's default IP address in the

Address field.

2.4 Change User Password

Old Password If you don't know the old password, you will

not be able to change it.

New Password Enter the router's new password.

Confirm Password Re-enter the router's new password to

confirm it.

Select the appropriate WAN connection type to connect to

the Internet. There are four modes available.

a. Static IP, b. DHCP, c. PPPoE, and d. PPTP.

If Static IP is selected, this screen will appear. Enter the

specified by your ISP, and then click Apply.

address

If you choose DHCP mode, your ISP's DHCP server will

assign a dynamic IP address to Vigor3300.

If your ISP uses PPPoE (Point-to-Point Protocol over

Ethernet), then click PPPoE. Once PPPoE is selected,

enter the

username and password

If your ISP uses PPTP (Point-to-Point Tunneling Protocol),

then click PPTP. Once PPTP is selected, enter the

username and password

The LAN connection setup comes with the following

parameters:

The default values for the router's local IP address and

Subnet Mask are 192.168.1.1 and 255.255.155.0.

You are able to change the default setting based on your

networking requirements.

Vigor3300 supports two modes –

NAT Usage – The source IP address will be translated into a

public IP for data transmission.

IP Routing Usage – The source IP address will be kept for

data transmission.

DHCP Server function enables the router to serve as a

DHCP server for your network. A DHCP server automatically

assigns an IP address and related parameters to each

computer on your network. You can specify the IP pool for

the router to start/end with when issuing IP address.

DHCP Server function is able to be used if IP Routing

Usage is enabled.

You can restrict the number of hosts requesting for the IP

related parameters from the DHCP server

The maximum is 10.

Note: You can also enter DNS server IP address for the

router in the Primary DNS field or Secondary DNS field

for the DHCP Server to assign to each host along with

its IP address.

provided by your ISP.