- ページ 2

ツール Alemlube HR90095のPDF オーナー技術マニュアルをオンラインで閲覧またはダウンロードできます。Alemlube HR90095 6 ページ。 Dual pedestal spring rewind hose reels

ページを印刷する

OWNER'S TECHNICAL MANUAL

GENERAL SAFETY REGULATIONS

WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot

cover all possible conditions or situations that could occur. It must be understood by the operator

that common sense and caution are factors that cannot be built into this product, but must

be supplied by the operator.

1. Keep the work area clean and dry. Damp or wet work areas can result in injury.

2. Keep children away from work area. Do not allow children to handle this product.

3. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger industrial

equipment. There are certain applications for which this equipment was designed. It will do the job better

and more safely at the capacity for which it was intended. Do not modify this equipment, and do not use this

equipment for a purpose for which it Was not intended.

4. Check for damaged parts. Before using this product, carefully check that it will operate properly and perform

its intended function. Check for damaged parts and any other conditions that may affect the operation of this

product. Replace damaged or worn parts immediately.

5. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury, etc.

6. Do not use the equipment when tired or under the influence of drugs, alcohol, or medication.

A moment of inattention while operating this equipment may result in serious personal injury.

SAFETY PRECAUTIONS

1. Make sure incoming line pressure does not exceed rated operating pressure for your model hose reel.

2. Use proper eye protection when assembling and using the hose reel.

3. Keep children away from the work area.

4. For long-time nonuse, please empty the hose

5. If long-term preservation of the hose reel, please check whether the hose is aging and whether the connecting

valve is leaking.

WARNING: Exposure of skin to pressurized air or fluid could result in severe injury.

INSTALLATION

For overhead ceiling and wall mounting: the installation height should not exceed 3m (10 feet) above the floor.

If the reel you have purchased does not have hose included, you will need to purchase and attach.

Refer to Specifications to determine appropriate hose and size.

1. The reel base has four 7/16" (11mm) drilled holes for mounting on a suitable flat surface.

The Mounting Template shows the correct location of the 4 mounting holes in the base.

2. The reel is supplied with a hose guide roller bracket. The bracket position may require repositioning depending

on the selected reel mounting position. If bracket position needs to be changed, do the following:

(1) Pull out some hose and let reel latch.

(2) Remove side cover and guide arm.

(3) Rotate guide roller bracket to correct position, replace bolts and tighten.

3. Using the four holes in the base, mount the reel in the desired location.

Be sure to use appropriate hardware and tighten securely.

4. Apply Teflon tape or pipe sealant to supply line threads, attach to reel inlet and tighten.

The other end of incoming line can now be connected to desired supply source.

5. If hose has been supplied with reel: Apply Teflon tape or pipe sealant to outlet fitting on reel hose, then

attach to desired tool, or nozzle. Check connection for leakage, also check hose reel for correct operation.

(Details see Operation section.)

6. If hose stopper adjustment is required, pull hose from reel and allow to latch at desired length. Loosen stopper

bolts and slide stopper to a position close to the hose guide. Tighten stopper bolts, and unlatch the reel.

NSW/ACT

QLD/PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

Dual Pedestal Spring Rewind Hose Reels

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

SA/NT

TEL: (08) 9302 4199

TEL: (08) 8241 7111

FAX: (08) 9303 2095

FAX: (08) 8241 7011

www.alemlube.co.nz

HR90000

Series

TEL: (09) 447 1007

FAX: (09) 447 1008