- ページ 25

洗濯機 Electrolux EW 1035 FのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux EW 1035 F 27 ページ。
Electrolux EW 1035 F にも：取扱説明書 (22 ページ), 取扱説明書 (25 ページ)

ページを印刷する

Something not working?

Problems which you can resolve yourself.

During machine operation it is possible that one of the following alarm codes appears on the display and at the

same time the light

starts to flash:

- E10: problem with the water supply

- E20: problem with water draining

- E40: door open

Once the problem has been eliminated, press the START/PAUSE button

all checks, the problem persists, contact your local Service Centre.

Problem

• The machine does not start up:

• The machine does not fill:

• The machine fills then empties

immediately:

• The machine does not empty

and/or does not spin:

• There is water on the floor:

• Unsatisfactory washing results:

to restart the programme. If after

Possible cause

• The door is not firmly closed. (E40)

• The machine is not plugged in or there is no power

at the socket.

• The main fuse has blown.

• The START/PAUSE button

depressed.

• The DELAY START option has been selected.

• The programme selector dial is not positioned.

• The water tap is closed. (E10)

• The inlet hose is squashed or kinked. (E10)

• The filter in the inlet hose is blocked. (E10)

• The door is not properly closed. (E40)

• The end of the drain hose is too low. Refer to

relevant paragraph in "water drainage" section.

• The drain hose is squashed or kinked. (E20)

• The option

• The laundry is not evenly distributed in the drum.

• The drain pump is clogged. (E20)

• Too much detergent or unsuitable detergent

(creates too much foam) has been used.

• Check whether there are any leaks from one of the

inlet hose fittings. It is not always easy to see this

as the water runs down the hose; check to see if it

is damp.

• The drain hose is damaged.

• The cap on the emergency emptying hose has not

been replaced after cleaning the pump.

• Too little detergent or unsuitable detergent has

been used.

• Stubborn stains have not been treated prior to

washing.

• The correct temperature was not selected.

• Excessive laundry load.

has not been

has been selected.