- ページ 2

ツール Alemlube SP610のPDF オーナー技術マニュアルをオンラインで閲覧またはダウンロードできます。Alemlube SP610 3 ページ。 Propane hose reel

ページを印刷する

Installation Of Reel

1 Prior to mounting the hose reel, ensure that the supply line pressure does not exceed the maximum working pressure

of the hose reel.

2 Unpack and inspect the reel for damage. Turn by hand to check for smooth operation. Check for completeness.

3 For overhead ceiling mounting: Install reel at most 10ft/3m above the floor.

4 You will need to purchase appropriate hardware for mounting your new reel.

A) The base has four 6.5mm drill holes for mounting on a suitable flat surface.

B) Using the four holes in the base, mount the reel in the desired location. Be sure to use appropriate hardware

and tighten securely.

5 IMPORTANT: Apply teflon tape or pipe sealant to supply line threads, attach to reel inlet and tighten.

The other end of incoming line can now be connected to the desired supply source.

6 IMPORTANT: Apply teflon tape or pipe sealant to outlet fitting on reel hose, then attach to desired tool or nozzle.

Check connection for leakage, also check hose reel for correct operation. See: Operation Section.

7 If hose stopper adjustment is required, pull hose from reel and allow to latch at desired lenth. Loosen stopper bolts

and slide stopper to a position close to the hose guide. Tighten stopper bolts and unlatch the reel.

Operation

1 Check your S Series reel for correct operation by slowly pulling out the hose. A clicking noise will be heard every half revolution

of the drum.

2 Latching mode switch, when your S Series reel is in free run state, pull out the hose and allow it to retract after hearing the first,

second or third click.

3 To unlatch the reel, slowly pull out the hose until the clicking noise stops, and then let the hose retract until the hose stop rests

against the hose guide.

4 If necessary, adjust spring tension on reel by adding or removing wraps of hose from spool, one wraps at a time, until desired

tension is obtained.Add wraps to increase tension. Remove wraps to decrease tension.

Warning

1. Make sure the hose is in proper working order.

2. Clean the hose with a cloth dipped in hot water to remove dirt or deposits and ensure correct rewinding.

3. Do not use detergents or solvents which could prove incompatible with cable-winder materials.

4. Dismantling of the unit by unskilled person could prove hazardous: the risk involved mainly concern the preloaded springs.

NSW/ACT

QLD/PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

OWNER'S TECHNICAL MANUAL

Propane Hose Reel

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

SA/NT

TEL: (08) 9302 4199

TEL: (08) 8241 7111

FAX: (08) 9303 2095

FAX: (08) 8241 7011

www.alemlube.co.nz

SP610

TEL: (09) 447 1007

FAX: (09) 447 1008