ページを印刷する
en Installation instructions
19.1 Important information
This appliance is designed for use up to a maximum
height of 4000 metres above sea level. Do not use the
door handle to transport or install the appliance. The
appliance must be disconnected from the power sup-
ply whenever installation work is being carried out.
¡ Only an appliance which has been correctly in-
stalled in accordance with these installation instruc-
tions can be used safely. The installer shall be liable
for damages incurred as a result of incorrect install-
ation.
¡ Check the appliance for damage after unpacking it.
Do not connect the appliance if it has been dam-
aged in transport.
¡ Proceed in accordance with the installation sheets
for installing accessories.
¡ Before starting up the appliance, remove any pack-
aging material and adhesive film from the cooking
compartment and the door.
¡ Fitted units must be heat-resistant up to 90 °C, and
adjacent unit fronts up to 70 °C.
¡ Do not install the appliance behind a decorative
door or the door of a kitchen unit. Risk of overheat-
ing.
¡ Cut-out work on the units should be carried out be-
fore installing the appliance. Remove any shavings.
Otherwise, the correct operation of electrical com-
ponents may be adversely affected.
¡ To prevent cuts, wear protective gloves. Parts that
are accessible during installation may have sharp
edges.
¡ Dimensions of the figures in mm
19.2 Appliance dimensions
You can find the appliance dimensions here.
36
¡ The mains socket for the appliance must either be
located in the hatched area A or outside of the area
where the appliance is installed.
¡ Secure freestanding units to the wall using a stand-
ard bracket B.
19.3 Installing the appliance below a
worktop
¡ To ventilate the appliance, the intermediate floor
must have a ventilation cut-out.
¡ Secure the worktop to the built-in unit.
¡ Observe the installation instructions for the hob.
19.4 Installation in a tall unit
¡ To ventilate the appliance, the intermediate floor
must have a ventilation cut-out.
¡ If the tall unit has another back panel in addition to
the element back panels, remove this.
¡ Only fit the appliance up to a height which allows
accessories to be easily removed.