- ページ 6

無線アクセスポイント Draytek VIGORAP 902のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Draytek VIGORAP 902 11 ページ。 802.11ac

Installation

This section will guide you to install the AP through hardware connection and

configure the settings through web browser.

Before starting to configure the router, you have to connect your devices correctly.

1. Connect VigorAP 902 to xDSL modem, router, or switch/hub in your

network through the LAN A port of the access point by Ethernet cable.

Note

2. Connect a computer to other available LAN A port. Make sure the subnet IP

address of the PC is the same as VigorAP 902 management IP, e.g.,

192.168.1.X.

3. Connect the A/C power adapter to the wall socket, and then connect it to the

PWR connector of the access point.

4. Power on VigorAP 902.

5. Check all LEDs on the front panel. ACT LED should blink, LAN LEDs

should be on if the access point is correctly connected to the xDSL modem,

router or switch/hub.

You can also connect VigorAP 902 to a Vigor router via

wireless connection. For detailed information, refer to

VigorAP 902 User's Guide.