- ページ 6

コントローラー Carlin 60200FRのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Carlin 60200FR 9 ページ。 Gas burner primary control
Carlin 60200FR にも：据付・取扱説明書 (8 ページ)

ページを印刷する

Operating Sequence

With power to the control and the gas valve open, set

thermostat (and limit) to call for heat. NOTE: The thermostat

circuit must be closed and power must be coming to black

wire from limit circuit.

During Pre-Purge, the motor starts.

Pre-Purge

Following Pre-Purge, the control advances to a

3 second Pre-Ignition

Pre-Ignition

During Pre-Ignition, the ignitor turns on and enters Trial for

Ignition.

Trial for Ign

Status Icons

Status Icons will appear at the top of the 60200FR display to indicate the control's current operating condition.

POWER

Indicates that the control is powered (flashes if voltage is too low or too high)

HV LIM

Indicates that the burner limit circuit is powered.

Displayed when the TT terminals are physically jumpered, jumpered in the set-up menu, or when thermostat

is calling for heat.

Monitors the BV contacts where a Blocked Vent Switch (Spill Switch) is connected. (Flashes if the Spill Switch

contacts are open – indicating that the vent is blocked). See Blocked Vent Operation below for more information.

FLAME

Indicates the control is sensing flame

FAULT

Flashes in unison with other status icons indicating a problem exists in that area

MOTOR

Indicates that the motor is energized (flashes if motor not detected)

IGNITOR

Indicates that the ignitor is energized (flashes if ignitor not detected)

VALVE

Indicates that the gas valve is energized (on entry to pump prime will flash if not detected)

Carlin Combustion Technology, Inc.

X X Sec

During Trial for Ignition, the gas valve opens. When flame is

detected, the screen will briefly display "Flame Detected" and

then procedes to Burner Running

Burner Running

When the Call for Heat ends (or a limit control interrupts the

burner circuit), the gas valve will turn off. The motor remains

on for the Post-Purge period. When the Post-Purge timer

expires, the control returns to Standby mode awaiting the

next call for heat.

Post-Purge

Standby

No Call for Heat

5 9 Sec

X X Sec

5 9 Sec

MN60200FR1 070319