- ページ 14

モデム Draytek Vigor 160 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Draytek Vigor 160 Series 20 ページ。 35b/g g.fast / vdsl2 modem

To use the Vigor 166 as a modem, connect a LAN port (P1/P2) to your router's

RJ-45 Ethernet (WAN) port.

Connect the DSL port of the Vigor 166 to your ISP's RJ-11 DSL wall socket or

microfilter.

Check the LED lights on the Vigor 166 to determine its connection status:

• The ACT light should be flashing slowly to indicate normal operation.

• The DSL light will be lit solidly when it has connected to a G.Fast or

VDSL2 connection and is ready to pass-through connectivity.

• The P1 or P2 LAN port light that's connected to your router will be lit to

indicate connectivity.

Once your router's Internet connection settings are configured with the correct

settings for your ISP the Internet connection will establish shortly after. If your

ISP provides a username and password, then your router should be configured to

PPPoE mode.

Once the Vigor 166 is connected to your G.Fast / DSL line, you can check the

[Online Status] > [Physical Connection] page for more information.

This displays connection status, DSL type, signal quality and the link speed

(e.g. 80Mb/s as shown below):

The [Dashboard] also shows a summary of DSL information with DSL port status

and the DSL link speed.