- ページ 10

エアコン Alen AMS12のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Alen AMS12 17 ページ。 Split type room air conditioner 9000 btu and 14.5 seer/12000 btu and 13.5 seer

ページを印刷する

EvAPORATOR INSTALLATION (INDOOR)

2) Connective Pipe and Drainage Installation

i) Drainage

Run the drain hose downward.

Do not install the drain hose as illus-

trated below.

Do not form a rise

ii) Connective Pipe

Pipe holder

Pipe cover

Right piping

Right back piping

a) For the left-hand and right-hand piping,

remove the pipe cover from the side panel.

Explain to the customer that the pipe cover

must be kept as it may be used if the air

conditioner is moved to another location.

b) For the left-hand and rear-left-hand pip-

ing, install the piping as shown. Bend the

connective pipe to be

placed at a height of 1 5/8 inches

or less from the wall.

Evaporator (Indoor) Unit outline

c) Fix the end of the connective pipe.

(Refer to Tightening Connection in

Refrigerant Piping Connection).

Do not put the hose

end into water

Pipe Cover

Left piping

Left back piping

Connective Pipe

iii) Piping and Bandaging

Wind the Connective cable, drain hose

and wiring tape securely, evenly as

shown below.

Evaporator (Indoor) Unit

Connective Cable

Drain Hose

3) Evaporator (Indoor)

Unit Installation

iii) Insert a spacer between the evaporator

(indoor) unit and the wall bracket to sepa-

rate the bottom of the unit from the wall.

iv) Push the lower part of the evaporator

(indoor) unit up on the wall. Then move

the evaporator (indoor) unit from side to

side, up and down to check if it is hooked

securely

Ponding Box

Pipe Room

Connective Pipe

Wrapping Belt

i) Pass the piping through

the hole in the wall

ii) Put the upper claw at

the back of the installation

plate, move the evaporator

(indoor) unit from side to

side to see if it is securely

hooked.