- ページ 10

オーブン Bosch Integra HDI7282UのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Bosch Integra HDI7282U 48 ページ。 Dual-fuel slide-in range
Bosch Integra HDI7282U にも：変換マニュアル (32 ページ), 取付説明書 (48 ページ)

ページを印刷する

Install strain relief

Place strain relief in knockout below terminal block.

WarnIng

The strain relief provided with your range cord must

be properly installed.

Strain reliefs vary. Carefully read and follow the in-

structions included with your strain relief.

1. In the knockout panel below the terminal block,

remove the knockout that fits your strain relief.

2. Feed range cord through hole and strain relief up

to terminal block. Allow for slack in the cord be-

tween the strain relief and terminal block.

3. Once cord length/slack has been adjusted, attach

strain relief per instructions included with strain

relief.

Feed range cord through strain

tip: The knockout panel (below the terminal block)

can be removed from the range to install the strain

relief: Remove panel from range, install strain relief

in panel and reattach. DO NOT remove entire range

back panel.

WarnIng

Risk of Electric Shock or Fire. Frame grounded to

neutral through a ground strap. Grounding through

the neutral conductor is prohibited for new branch-

circuit installations (1996 NEC), mobile homes, and

recreational vehicles, or in an area where local codes

prohibit grounding through the neutral conductor.

For installations where grounding through the neu-

tral conductor is prohibited, (a) disconnect the link

from the neutral, (b) use grounding terminal or lead

to ground unit, (c) connect neutral terminal to lead

branch circuit neutral in usual manner (when the

appliance is to be connected by means of a cord kit,

use 4-conductor cord for this purpose).

Electrical connection

(found behind terminal block cover)

relief in knockout panel here.

Use only cord kits rated 125/250 volts (minimum),

30 amperes and labeled "For Use with Ranges".

Strain relief provided with cord must be installed per

instructions included with cord.

WarnIng

To prevent electrical shock, the grounding prong on

the range cord should not be cut or removed under

any circumstances. It must be plugged into a match-

ing grounding type receptacle and connected to a

correctly polarized 240- Volt circuit. If there is any

doubt as to whether the wall receptacle is properly

grounded, have it checked by a qualified electrician.

Four Wire range cord connection

(recommended method)

1. Disconnect electrical power at breaker box.

Remove the terminal block cover to expose the

terminal block.

2. Remove top nut, star washer, and round washer

from each post.

note: DO NOT remove last round washer, last nut or

internal wiring leads.

3. Remove screw from bottom end of ground strap.