- ページ 10

シンセサイザー Dreadbox HADESのPDF コンストラクション・マニュアルをオンラインで閲覧またはダウンロードできます。Dreadbox HADES 12 ページ。 Analog bass synthesizer
Dreadbox HADES にも：ユーザーマニュアル (8 ページ), ユーザーマニュアル (8 ページ), オーナーズマニュアル (7 ページ)

ページを印刷する

Step 7 - Tuning

This is the most challenging part of the build.

First thing you should do, is to prepare your

workbench. Make sure that your working area is all

cleaned up and we strongly suggest to use the foam

to support the module.

1. Connect a patch cable from the 1v/OCV output.

2. Use the crocks to connect the multimeter with the

minijack as shown. The red goes to the tip and the

black goes to the ground. Then turn the multimeter

on to the DC voltage measurement.

3. Connect the module to a USB power source.

IMPORTANT NOTE: To enter the calibration mode

you must flip the OMNI/CHAN switch 6 times in the

first 10 seconds that the unit is powered.

4. After entering the calibration mode :

- Set A, D/R and S knobs (from the Envelope) to

about 50% travel.

- Set the LEG/OFF switch to the OFF position

- Flip the DR/R switch until the multimeter shows

about 0V.

- Now flip the DR/R switch again.

- The multimeter will show a measurement of about

3volts. Use the "A" knob to set it as close as possible

to 3 volts. The ideal voltage is 3.000mV (3V =

3000mV) but that is not always possible. You can

allow a 0,010 offset with no problems.

- Then flip the DR/R again. The multimeter will show

about 6 volts. This time use the D/R knob to set it to

6.000 volts.

- Then flip the DR/R switch one last time. The multi

meter will show about 9 volts. Use the S knob to set

it to 9,000.

IMPORTANT NOTE: After setting it up make sure not

to touch these knobs again while in calibration

mode, because the setting will be lost and you will

need to run the process again.