ページを印刷する
Operating The Sound System
1. Place the AN-130 at desired location.
NOTE:
If no sound
2. Set volume control on front of speaker to minimum before
can be
turning on the power.
heard after
3. Plug the power cord into a grounded 115 volt outlet (220
increasing
volt outlet for export model).
the volume
of your
4. Plug a microphone into the MIC input jack, or an audio
AN-130RC,
source into the INST or LINE 1 / LINE 2 jacks.
lower the
5. Turn the power switch "ON" (the red LED on front panel
volume, turn
should light).
the power
6. Adjust the volume, bass and treble controls for desired
switch off
sound.
then back on.
Next slowly
increase the
volume to the
desired level.
AN-130U1 Back Panel
Mic Input
Instrument Input
(1/4" phone jack)
(1/4" phone jack)
CAUTION:
ALWAYS use
shielded
audio cables
on input
connections
to prevent
interference.
Wireless Mic Volume Control
4
GENERAL OPERATION
Line Inputs - 2
(RCA jacks)
Wireless Channel Selector
WIRELESS REMOTE CONTROL
Remote Operation (AN-130RC only)
With the red, mute button facing towards the AN-130RC, aim the
remote at the red window located near the volume and tone controls.
Press the volume up button to increase the volume. Press the volume
down button to decrease the volume. To mute the AN-130RC, press
the mute button. To un-mute press the mute button again, or press
either volume button.
Volume Down
Button
Replacing The Remote Battery
With the bottom of the remote facing up, locate the latch on the
bottom of the remote, near the back. Gently pull the latch towards
the center of the remote and carefully slide out the battery holder.
Place a new battery in the holder so that the positive symbol on the
battery is facing up. Carefully re-insert the battery holder. Use only
CR2025 or CR2032 type batteries.
Mute Button
Volume Up
Button
9