- ページ 18

楽器 Dream 2655PIA-DKのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Dream 2655PIA-DK 20 ページ。 With sam2655

8.7.

Components test

Components test will automatically and consecutively test DataFlash device, each of the parallel ROM or Flash

devices and Firmware integrity. Even if Firmware is part of the first ROM or flash device, it should be checked

separately

To start component test press and hold MINUS switch then also press PLUS switch.

Firmware enters in component test and display shows:

- "dFl" while DataFlash is under test

- "rOM" while ROM or Flash devices are under test

- "Fir" while Firmware integrity is under test

When test is ended, state of the 5 first Intrument LEDs shows the test result. If the 5 LEDs are on then all

components test were successfully passed.

- If Inst 1 LED is off then DataFlash test was fail

- If Inst 2 LED is off then ROM or Flash device test was fail

- If Inst 6 LED is off then Firmware test was failed

Warning: ROM and Firmware test can be passed with success only if binary files for ROM or FLASH devices have

been created with Dream "MakeROM.exe" tool.

8.8.

SAM2655 test

SAM2655 test will test internal chip elements.

To start component test press and hold MINUS switch then also press PLUS switch.

Steps are:

1- Play sine wave at 1.5kHz frequency

2- Test 32kx16 RAM

3- Change sine wave frequency to 750Hz

If test is success then a full scale, 750Hz, sine wave signal will be generated on main audio L and R output. It could

be useful for checking analog output stage of the product

Warning: Firmware stays in an endless loop at the end of the test. To recover normal playing mode, product should

be restarted.

2655PIA-DK_Rev0 – User's Manual

2655PIA-DK Users Manual - Rev. 03/13