- ページ 7
スピーカー Anchor MegaVox PRO MEGA-6000のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Anchor MegaVox PRO MEGA-6000 8 ページ。 Portable public address system
Anchor MegaVox PRO MEGA-6000 にも： カタログ (2 ページ), オーナーズマニュアル (4 ページ), 仕様 (1 ページ), オーナーズマニュアル (16 ページ)
ページを印刷する
MegaVox Pro Control Panel
NOTE:
1. Set all input level controls to minimum before turning on the
Instructions
power.
for wireless
2. Plug a microphone into a Mic jack, or an audio source into
operation can
the Line-in jack.
be found on
3. Turn POWER on, the red LED near the switch will light. If
page 10.
the LED flashes or dose not light, charge the battery.
4. Slowly increase the level control adjacent to the input jack
used to desired volume.
Power/Battery Indicator
Wireless
Receiver 1
Wireless
Receiver 1
Controller
Wireless
Receiver 2
Controller
MEGA-6000U2
Back Panel
NOTE:
Charger Input
All in/out line
connections
must be made
with shielded
MEGA-6000U1
cable to avoid
Back Panel
hum, buzzing,
or radio
interference.
Wireless Receiver/
Mic Controller
8
GENERAL OPERATION
Power Switch
Signal Alert Button
Mic/Signal Alert
Controller
Wireless
Receiver 2
Line In
Controller
Line Out Jack
Line In Jack
Speaker Out
Jack
Charging Indicator
Mic In Jack
Mic Controller
MEGA-6000
Back Panel
Daisy-Chaining
By using the Line Output method described above you can connect
up to six powered MegaVox Pro PA Systems together expanding
your coverage area.
MegaVox Pro
Daisy-Chain
Daisy-Chain Setup
NOTE:
To connect your MegaVox Pro units, use a shielded cable with 1/4"
Auditoriums
phone plugs on each end (EX-50PP).
or outside
1. Turn the power switch off and turn the volume to maximum
areas with
on each MegaVox Pro.
large exposed
walls or
2. Connect the Line Out on the primary (first) MegaVox Pro to
patios may
the Line In on the next MegaVox Pro.
create multiple
reflections of
the original
sound.
Altering the
PA system
position will
Primary
minimize the
Powered
sound
MegaVox Pro
reflections.
3. Continue connecting your powered MegaVox Pro systems
Line Out to Line In to complete your chain.
4. Power on the speakers in order, primary unit first. This will
avoid speaker popping which can cause damage.
5. Use the volume control on the primary unit to set the volume
for the entire chain.
6. Power off speakers in reverse order, primary unit last. This
will avoid speaker popping which can cause damage.
SYSTEM SETUP
Secondary
Powered
MegaVox Pro
Line Out - to - Line In Connection
5