- ページ 10

電動工具 Bosch 1617EVSPKのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch 1617EVSPK 24 ページ。 Router tools
Bosch 1617EVSPK にも：ユーザーマニュアル (34 ページ)

ページを印刷する

BM 2610018532 01-12:BM 2610018532 01-12.qxp 1/23/12 9:21 AM Page 10

A wide assortment of router bits with different

profiles is available separately. Use 1/2"

shank whenever possible, and only use good

quality bits.

To prevent personal injury,

WARNING

always remove the plug

from power source before removing or

installing bits or accessories.

INSTALLING A ROUTER BIT

Place router upside down or lay router on its

side with the base resting on the bench.

Another option is to remove the motor from

the base before installing the bit.

1. Remove the chip shield (or flip up if plunge

base is attached.

2. Hold the armature shaft in place with the

shaft wrench (Fig. 4)

3. Next, use the collet wrench to loosen the

collet chuck assembly in counter-

clockwise direction (viewed from under the

router).

4. Once you have verified that the bit's shank

is of the proper diameter for the collet to

be used, insert the shank of the router bit

into the collet chuck assembly as far as it

will go, then back the shank out until the

cutters are approximately 1/8" to 1/4" away

from the collet nut face.

5. With the router bit inserted and the shaft

wrench holding the armature shaft, use the

collet wrench to firmly tighten the collet

chuck assembly in a clockwise direction

(viewed from under the router). To ensure

proper gripping of the router bit and

minimize run-out, the shank of the router

bit must be inserted at least 5/8".

COLLET CHUCK CARE

With the router bit removed, continue to turn

the collet chuck counter-clockwise until it is

free of the shaft. To assure a firm grip,

occasionally blow out the collet chuck with

compressed air, and clean the taper in the

armature assembly shaft with a tissue or fine

brush. The collet chuck is made up of two

component parts as illustrated (Fig. 5); check

to see that the collet is properly seated in the

collet chuck nut and lightly thread the collet

Assembly

FIG. 4

COLLET

WRENCH

To tighten or loosen collet nut, hold both

wrenches in one hand and and squeeze

the wrenches together.

WARNING

base, do not use router bits greater than

2" in diameter as they will not fit through

the sub-base.

WARNING

opening for the bit and cutter.

CAUTION

without a bit.

NOTE: The bit shank and chuck should be

clean and free of dust, wood, residue and

grease before assembling.

REMOVING THE ROUTER BIT

1. Use the shaft and collet chuck wrenches

as described earlier, and turn the collet

chuck assembly in a counter-clockwise

direction.

2. Once the collet chuck assembly is

loosened continue to turn the collet chuck

assembly until it pulls the collet free from

its taper, and the router bit can be

removed.

NOTE: The collet chuck is self-extracting; it

is NOT necessary to strike the collet chuck to

free the router bit.

chuck back onto the armature shaft. Replace

worn or damaged collet chucks immediately.

FIG. 5

COLLET

NUT

-10-

SHAFT

WRENCH

When the templet guide

has been removed from

Cutter diameter must be at

least 1/4" smaller than

To prevent damage to

tool, do not tighten collet

COLLET

CHUCK