- ページ 4
スピーカー Anchor MiniVoxのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Anchor MiniVox 4 ページ。 Portable sound system
Anchor MiniVox にも： オーナーズマニュアル (7 ページ), クイック・スタート・マニュアル (2 ページ), オーナーズマニュアル (10 ページ)
ページを印刷する
BASIC SYSTEM OPERATION
NOTE: Batteries Must Be Installed Before Use!
1. Position the MiniVox with the front/speaker facing toward
your audience
2. Plug the wired microphone into the MIC jack
(MIC-25 wired microphone is included)
3. Turn the MiniVox Power/Volume Level knob on, the red
BATTERY LED will light and remain lit during operation
4. Set the wired microphone power switch to ON
5. Adjust the volume with the Power/Volume Level knob
IMPORTANT: To avoid feedback, do not position
a microphone in front of speaker.
PROBLEMS? Consult the troubleshooting section on
the back page of this manual.
MINIVOX PA SYSTEM
MiniVox is a battery-operated handheld Public Address system that's
easy to set-up & operate. Before using the MiniVox, you'll need to in-
stall the batteries as described below right.
If your unit is equipped with an RC-25 rechargeable battery kit, you
must charge the batteries completely before use (see page 3).
MINIVOX ACCESSORIES
MIC-25 - Handheld Microphone
Handheld microphone w/ 6' coil cord & 1/4" connector.
MIC-90P - Handheld Microphone
Dynamic, balanced, low impedance microphone w/ unidirectional
pick-up pattern & 1/4" connector. Comes w/ 20' cable, storage
case & mic clip.
RC-25 - Rechargeable Battery Kit
Includes (9) rechargeable batteries and AC adapter/charger.
CC-25 - Carrying Bag
Vinyl carrying bag with storage pocket for microphone.
NOTE: See page 6 for wireless microphones
& UHF transmitters.
4
BATTERY LED
Light will dim as battery power
runs low, when light turns off it
is time to replace batteries
POWER / VOLUME LEVEL
CD / TAPE INPUT JACK
3.5 mm mini jack - mono
MICROPHONE INPUT JACK
Phantom powered mic inpu t for
electret condenser microphones
that require phantom power;
3.5 mm mini jack
AC-25 CHARGER INPUT JACK
2.5 mm sub-mini jack
LO-Z MIC INPUT JACK
1/4" phone jack - unbalanced
1. Remove the battery compartment cover located on the bottom of the
MiniVox by turning the slotted fastener 1/4-turn counter-clockwise
2. Insert three "C" size batteries (alkaline-type work best) into each
cardboard battery-holder as shown
BATTERY INSTALLATION
3. Position the three battery tubes into the battery compartment with
negative (flat) end contacting the springs (see label in compartment)
4. Replace the battery compartment cover and lock it in place by turning
the fastener 1/4-turn clockwise
IMPORTANT: Use alkaline batteries for extended
service life & greater output!
WIRELESS RECEIVER
CONTROLS
See page 6
MINIVOX PA SYSTEM
CONTROL PANEL
Model Shown: PB-25U1