- ページ 6

スピーカー Anchor MiniVoxのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Anchor MiniVox 7 ページ。 Portable sound system
Anchor MiniVox にも：オーナーズマニュアル (4 ページ), クイック・スタート・マニュアル (2 ページ), オーナーズマニュアル (10 ページ)

ページを印刷する

Operation

Phantom Powered

Microphone Input

Use the phantom powered mic input (3.5mm jack) with electret

condenser microphones that require phantom power; such as

Anchor's CM-1000 and HBM-35.

Using the RC-25 rechargeable battery kit

For applications where the MiniVox is used frequently, the

RC-25 rechargeable battery kit is available. The kit includes

rechargeable batteries and an AC charging adapter. About

8-15 hours of operation can be expected per charge.

Using the RC-25 Recharge Kit

1. Install batteries as described on page 4.

2. Insert small plug on charger into CHARGER input on

the MiniVox and plug AC adapter into an outlet.

3. Note! Charge batteries for 24 hours before using

MiniVox for the first time. Typical charging time for

full recovery is 12-18 hours.

Recharge

CAUTION: NEVER recharge other types of batteries.

batteries before

storing.

Doing so can result in battery explosion. Use only

Do not charge

rechargeable Nickel Cadmium (NiCad) batteries.

batteries for

4. Cycling the batteries: To extend battery life, we

more than 24

hours!

recommend you fully charge the batteries once each

month during periods of infrequent use. Always

recharge batteries before storing.

Optional Signal Alert: Model PB-25SA

The Signal Alert button enables the MiniVox to produce a

siren-like tone. The momentary pushbutton switch on the

handle actuates the alert (the volume of the alert tone is not

affected by the MiniVox volume control).

MICROPHONE

(PHANTOM POWER)

Wireless Operation

(model PB-25W only)

Setting up the wireless system

Set the frequency of the receiver.

The wireless receiver is mounted inside the MiniVox. and is

available with two different frequency pairs (this allows for

operation of up to 4 units simultaneously). A label on top of

the MiniVox indicates which 2 frequencies your system is

equipped with, and the desired frequency is selected via the

frequency switch.

label indicates frequency pair

169.445

170.245

PB-25W-1: 169.445

PB-25W-2: 171.105

frequency switch

1. Set the frequency of the receiver to either of the two

channels, F1 or F2.

If you experience ongoing interference problems with your

wireless system, the selected frequency may be incompatible

with other RF systems in your area. Try the other channel.

Set the frequency of the transmitter.

During use, make sure the transmitter you are using is set to

the same frequency as the receiver as set above.

HANDHELD: Set the frequency switch inside the

battery compartment to match the channel of the

receiver. Replace the cover—but don't overtighten!

Frequency Switch

BODY-PACK: The power/frequency switch on the

transmitter determines the frequency. During use, set

the switch to match the frequency of the receiver.

(MHz)

170.245

171.845