- ページ 4

スピーカー Anchor MiniVox Lite PB-30U1のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Anchor MiniVox Lite PB-30U1 4 ページ。 Minivox lite pa system
Anchor MiniVox Lite PB-30U1 にも：仕様 (1 ページ), 技術仕様 (1 ページ)

ページを印刷する

BASIC SYSTEM OPERATION

NOTE: Batteries Must Be Installed Before Use!

1. Position the MiniVox Lite with the front/speaker facing

toward your audience

2. Connect a microphone to the one of the MIC jacks

(1/4" MIC jack or 3.5 mm PWR MIC mini jack)

3. Turn the MiniVox Lite Power/Volume Level knob on, the

red POWER LED will light and remain lit during operation

4. Set the microphone power switch to ON

5. Adjust the volume with the Power/Volume Level knob

IMPORTANT: To avoid feedback, do not position

a microphone in front of speaker.

PROBLEMS? Consult the troubleshooting section on

the back page of this manual.

MINIVOX LITE PA SYSTEM

MiniVox Lite is a battery-operated handheld Public Address system

that's easy to set-up & operate. Before using the MiniVox Lite, you'll

need to install the batteries as described below right.

If your unit is equipped with an RC-30 rechargeable battery kit, you

must charge the batteries completely before use (see page 3).

MINIVOX LITE ACCESSORIES

MIC-50 – Handheld Microphone

Handheld microphone w/ 6' coil cord & 1/4" connector.

MIC-90P – Handheld Microphone

Dynamic, balanced, low impedance microphone w/ unidirectional

pick-up pattern & 1/4" connector. Comes w/ 20' cable, storage

case & mic clip.

HBM-MINI – Headband Microphone

Ultra-lightweight headband microphone w/ 3.5 mm mini plug

RC-30 – Rechargeable Battery Kit

Includes 10 rechargeable "AA" batteries and AC adapter/charger.

NOTE: See page 6 for wireless microphones

& UHF transmitters.

POWER LED LIGHT

ON BRIGHT: AN-Mini power is turned on

ON DIM: LED dims as battery power runs low

OFF: Replace or recharge batteries

CHARGE LED LIGHT

ON: Optional RC-30 rechargeable battery

charger plugged in and batteries charging

OFF: Rechargeable batteries fully charged

DC IN – INPUT JACK

Use ONLY with the DC charger

that comes in the optional RC-30

rechargeable battery kit

POWER / VOLUME LEVEL

1. Remove the battery compartment cover located underneath the control

back panel of the MiniVox Lite by pressing down the lock tabs of the bat-

tery compartment cover

2. Slide out the battery pack from the MiniVox Lite battery compartment

3. Insert ten 'AA' size batteries (alkaline or RC-30 rechargeable batteries)

into the battery pack Position the ten battery tubes into the battery pack

by following the polarity labels on the battery pack

MIC BOOST BUTTON

Push to give your voice an added boost when

speaking to a larger crowd or in a noisy

environment

To return to normal use push the "MIC

BOOST" button again.

LINE IN – INPUT JACK

1/8" (3.5 mm) - For any line-level

signal source: iPod, MP3/tape/

VCR/CD/DVD players, musical in-

struments, etc.

LINE OUT – OUTPUT JACK

1/8" (3.5 mm) - Balanced, combined output of all active system inputs

Record your presentation or connect to another powered sound system

Post source level output; any volume fluctuations for a specific input

will affect this output signal level

BATTERY INSTALLATION

4. Slide-in the battery pack into the battery compartment Push the battery

pack all the way in

5. Replace the battery compartment cover and push cover to lock tabs

in place

WIRELESS RECEIVER INSTRUCTIONS

SEE PAGE 6

POWERED MIC

1/8" (3.5 mm) - Phantom

powered for electret condenser

microphones that require

phantom power

MIC - INPUT JACK

1/4" Phone - Unbalanced,

low impedance,

no phantom power