- ページ 5

アンテナ Dream Catcher ME1310のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dream Catcher ME1310 18 ページ。 Antenna and propagation (3d) lab 1 introduction to 3d radiation pattern measurement

ページを印刷する

1. Introduction

Antenna Radiation Pattern Measurement

2.1 2400 MHz Dipole Antenna Measurement

Note: To get the best accuracy, you should perform calibration before making any measurements on your

network analyzer. The recommended calibration kit is the Keysight 85033E. Please refer to Appendix B,

Calibration" for the calibration procedure.

1. Set up the equipment as shown in Figure 2.

2. Two 2400 MHz 2 dipole antennas are used for the measurement. Mount one of the dipole

antennas on the top connector of the fixed antenna holder on the transmitter module (Tx). This is

the transmitting antenna. Orientate the antenna for vertical polarization and broadside to the other

antenna-under-test (AUT). The orientation of the transmitting and receiving antennas are shown

in Figure 4.

3. Use an RF coaxial cable to connect the RF OUT connector of the N9912A FieldFox RF analyzer

to the RF IN connector of the transmitter module (Tx).

ME1310 Antenna and

Propagation (3D)

Figure 2 – Equipment setup

http://dreamcatcher.asia/cw

Lab 1 - 5/18