- ページ 13

食器洗い機 Electrolux Built-In DishwasherのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux Built-In Dishwasher 18 ページ。 Built-in oven
Electrolux Built-In Dishwasher にも：取扱説明書 (12 ページ), オーナーズマニュアル (13 ページ), 取扱説明書 (17 ページ), 取扱説明書 (15 ページ), インストラクションブック (18 ページ), 取扱説明書 (18 ページ)

ページを印刷する

What to do if ...

Correcting Malfunctions

A malfunction may be caused by only a minor fault

that you can rectify yourself using the following

instructions. Do not perform any other work on the

appliance if the following information does not provide

assistance in your specific case.

Malfunction

Appliance does not work.

Appliance cools too much.

The food is too warm.

Interior lighting does not work. Light bulb is defective.

Heavy build up of frost, possi-

bly also on the door seal.

The compressor does not start

immediately after changing the

temperature setting.

Water on the floor or on stor-

age shelves.

Possible Cause

Appliance is not switched on.

Mains plug is not plugged in or is

loose.

Fuse has blown or is defective.

Socket is defective.

Temperature is set too cold.

Temperature is not properly adjusted.

Door was open for an extended

period.

A large quantity of warm food was

placed in the appliance within the last

24 hours.

The appliance is near a heat source.

Door seal is not air tight (possibly after

changing over the hinges).

This is normal, no error has occurred.

Water drain hole is blocked.

Warning! Repairs to refrigerators/freezers

may only be performed by qualified service

engineers. Improper repairs can give rise to

significant hazards for the user. If your appli-

ance needs repairing, please contact your

specialist dealer or our Customer Service.

Switch on the appliance.

Insert mains plug.

Check fuse, replace if necessary.

Mains malfunctions are to be cor-

rected by an electrician.

Turn the temperature regulator to a

warmer setting temporarily.

Please look in the "Starting up - Set-

ting the temperature" section.

Open the door only as long as neces-

sary.

Turn the temperature regulator to a

colder setting temporarily.

Please look in the "Where to Install"

section.

Please look in the "Changing the Light

Bulb" section.

Carefully warm the leaking sections of

the door seal with a hair dryer (not

hotter than approx. 50 °C). At the

same time shape the warmed door

seal by hand such that it sits correctly.

The compressor starts after a period

of time.

See the "Cleaning and Maintenance"

section.

Remedy