- ページ 4

温度コントローラー Athena 3020 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Athena 3020 Series 20 ページ。 Analog temperature controllers

Output

Configurations

Preliminary

Instructions

Type "B"

Type "F"

Type "L"

Type "T"

Type "S"

Unpacking

Carefully unpack the instrument, inspect for shipping dam-

age. Report any damage to the carrier immediately.

Locating

Select a location for the controller where it will not be subject-

ed to excessive shock, vibration, dirt, moisture or oil. The

ambient temperature of the area should be between 30° and

130° F. (Dust, oil, water resistant cover is available to protect

from harsh environments. Contact factory for details.)

Mounting

Mount controller into 92 mm (3-5/8") square cutout (1/4-

DIN). See Figure 1 for cutout and case dimensions. The

plug-in controller does not have to be removed from its hous-

ing for mounting.

Remove the two screws in the back of the case that hold the

mounting slides, and then remove the slides. Insert case

from front of panel and reinstall the two slides and two

screws. The length of the slides must be reduced if the con-

troller is to be mounted in an extra thick panel. If the con-

troller has been unplugged from its housing, the top of the

housing can be determined by the serial number tag.

Figure 1: Cutout and case dimensions

Relay with 7 A at 120 V and 5 A at 240 V

contacts, on-off and time proportioning

Signal current, 4-20 mAdc

Relay with 7 A at 120 V and 5 A at 240 V

contacts, on-off, reset switch

Solid state relay 1 A, 120/240 V resistive

load; 1 A, 120/240 V, 10 A inrush,

inductive load (not U.L. rated)

Pulsed 20 Vdc, for driving solid state

relays